AEG 1246 EL, 1046 EL manual Installation, Unpacking

Page 39

132986190.qxd 16/02/2005 11:56 Pagina 39

Installation

Unpacking

All transit bolts and packing must be removed before using the appli- ance.

Using a	spanner,
unscrew		and
remove the 2 rear
bottom	screws.
Slide out the 2
plastic	pins.	Lay
the machine on its
back, taking		care
not to squash the			P1129
not to squash the

hoses. This can be

avoided by placing one of the corner pack- ing pieces between the machine and the floor.

P0001

1 2

Remove the polystyrene block from the

bottom of the machine and release the 3 two plastic bags.

Carefully slide out the left-hand bag remov-		P1124
ing it towards the
right and then
downwards.
Slide out the
right-hand bag
removing it
towards the left
and then upwards.
Set the machine	P1126	P1127
	P1126
upright and
remove the
remaining rear
screw. Slide out
the relevant pin.
Plug the open
holes with the
plugs which you	P1128	P0002

will find in the plastic bag containing the instruction booklet.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

39

Image 39

Contents Washing Machine Instruction Booklet Dear customer Contents Programme charts wash and special programmes Follow the instructions for positioning and connection Safety instructionsGeneral safety Positioning, connection, starting upProper use Child safetyMachine DisposalTips for environmental protection Packaging materialsMain features of your washing machine Front view Description of the applianceProgramme selector dial Control panelSTART/PAUSE button Delay Start buttonPrewash Programme Option buttons1046EL 1246EL DisplayProgramme progress display Cancelling a programme Altering a programme which is runningOpening the door after the programme has started Before the first wash Detergent dispenser drawerSorting out and preparing the laundry Preparing the wash cycleCotton Weight of laundrySort of laundry Approximate Dry weights Types of fabric and care labelsDelicates Detergents and additives How to wash Load the laundryAdd detergent and additive Selection of the desired options Selection of the spin speed or Rinse Hold option1046 EL 1246 EL Selection of the Delay Start option Selection of the Extra Rinse optionBefore starting Starting the programme At the end of the programme Wash programmes Programme chartSpecial programmes DescripMax Consumption Tion Detergent dispenser drawer Cleaning and maintenancePeriodical cleaning Exterior After each washDoor seal Drain pumpWater inlet filter Emergency emptying out Frost precautionsTroubleshooting Problem Possible cause SolutionSomething not working? Possible cause Solution ProblemDistributed Problem Possible causeWhite residue is left on the laundry Unsatisfactory washing resultsIf grey stains remain on the laundry Foam is still visible even after the last rinseThis appliance complies with the following EC directives Technical dataService Safety instructions for the installer Instructions for installation and electrical connectionDimensions of the appliance Front view and side viewRear view Unpacking InstallationPositioning LevellingWater inlet Electrical connection Water drainageConnect the machine to an earthed socket Permanent connectionQxd 16/02/2005 1156 Pagina From the Electrolux Group. The world’s No choice