Before Using Your Portable Washer

INSTALLATION INSTRUCTIONS

∙Remove the exterior and interior packing.

∙You will need the following tools:

∙Wrench

∙Pliers

∙Screwdriver

∙Check to be sure you have all of the following parts:

∙2 Inlet Hoses

∙1 Faucet Adapter

∙1 Noise Proof Plate With Screws

∙1 Drain Hose Assembly

∙1 Water Inlet Plug

SCREWDRIVER
WRENCH	PLIERS

∙Remove shipping brace. Note - It should be saved and used (to prevent damage to washer components) whenever washer is moved or transported to a new location.

∙Clean the interior surface with lukewarm water using a soft cloth.

∙Allow 2 inches of space between the back and sides of the appliance.

∙Put your laundry into the washer evenly. Uneven laundry may cause noise or vibration.

∙DO NOT use excessively hot water (122ºF / 50°C or more). Plastic parts may be deformed or damaged. Also, clothing may be deformed or bleached.

∙Before washing, check all pockets. If nails or pins remain in pockets, they may damage the washer or clothes.

∙Never splash water on the control panel.

∙Plug the washer into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an Authorized Avanti Products service center.

SELECTING A LOCATION

Before you install the portable washer, select a location with the following characteristics:

∙A hard level surface (if the surface is uneven, see Adjusting The Adjustable Foot section on the next page).

∙Away from direct sunlight. Direct sunlight may affect the acrylic coating, plastic and electrical components.

∙Adequate ventilation.

∙Away from sources of heat such as coal or gas. Make sure that the washing machine does not stand on its power cord.

∙Ventilation openings must not be obstructed by carpeting when the portable washer is installed on a carpeted floor. It is recommended that you place your portable washer on a hard material floor such as tile, concrete, linoleum and to avoid if at all possible placement on wooden floors or carpeted areas.