Using the exhaust control
(on some models)
The Exhaust Control allows you to circulate room air or exhaust stale/smoky air.
l To circulate room air (Figure 7) set Exhaust Control to
CLOSED.
l To exhaust stale/smoky air set Exhaust Control to OPEN.
Exhaust control tips
lFor maximum cooling efficiency, set the Exhaust Control to CLOSED.
lThe Exhaust Control will only function when the System or Fan Control is turned to an “on”setting.
Using the ENERGY SAVER settings
(on some models)
The ENERGY SAVER settings are located on the System Control (QUICK COMFORT/HI, MED, and LO). See Figures 8 and 9. When these settings are selected, the fan will cycle on and off as the Thermostat Control turns the compressor on and off. This saves the cost of electrical energy that would be used to run the fan continuously.
It is normal for the fan to turn on and off in the ENERGY SAVER settings. The amount of time the unit will be off depends on the room temperature and Thermostat Control setting.
Energy saving tips
You can help save energy by reducing your air conditioner’s work load:
lImprove your home’s insulation. Seal doors and win- dows. Close fireplace flue.
lClose blinds or drapes on the sunny side of your house. Add awnings.
l
l
l
l
l
l
l
Check air filter often to make sure it is clean. Do not block airflow with drapes or furniture.
Ventilate your attic. High temperatures in the attic add to the cooling load of your air conditioner.
Try not to use
Turn lights and appliances off when they are not needed. Keep heat registers and
Use exhaust/venting fans while cooking, bathing, and doing laundry.
Changing air direction
The louvers in the top of the front panel allow you to control the direction of the cooled air. Use the tabs to direct the air right, left, or straight ahead. See Figure 10.
