ThisUsersection contains informationGuideabout the operating features of the Radiance access line cards.
LED Indicators
The Radiance access line cards provide several LEDs on the front panel for the visible verification of unit status and proper functionality. These LEDs can help with troubleshooting and overall network diagnosis and management. There are separate receive (RX), link (LK), loopback (LBK) and disable (DIS) indicators for each port.
The following table describes the indication of each LED when lit.
LED | LED |
|
|
Label | Name | Color (Status) | Indication |
MAN | Managed | Green (steady) | Unit is receiving management packets.* |
|
|
|
|
FD | Full Duplex | Green (steady) | Unit is operating at full duplex. When |
|
|
| unlit, the unit is operating at half duplex. |
|
|
|
|
PWR | Power | Green (steady) | Unit is powered ON. |
|
|
|
|
RX | Receive | Green (blinking) | Port is receiving data. |
|
|
|
|
LK | Link | Green (steady) | Port has a valid link. |
|
|
|
|
LBK | Loopback | Green (steady) | Port is in loopback mode. |
|
|
|
|
DIS | Disable | Green (steady) | Port has been disabled by software. |
|
|
|
|
*NOTE: A management card must be installed in the chassis to enable remote management.
Factory Settings
The Radiance access line card provides several
Default Hardware Switch Settings
| Parallel (UP) |
The following switches can be overridden through software commands.* | |
Link Loss Carry Forward | Disabled (DOWN) |
Disabled (DOWN) | |
Link Loss Return | Disabled (DOWN) |
Far End Fault | Disabled (DOWN) |
*Refer to the Command Line Interface Reference Guide, NetBeacon Element Management Software Installation & User Guide or WebBeacon Management Software Installation & User Guide for software management information.
12 User Guide
