AEG 2252 F Electrical connection, Permanent connection, Connect the machine to an earthed socket

Page 41

Installation 41

P1118

Important!

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre.

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point. This operation must be performed by a qualified electrician.

The power supply cable must be easily accessible after installing the machine.

Should the appliance power supply cable need to be replaced, this must be carried out by a Service Centre.

Image 41
Contents Lavamat Princess 2252 F Dear Customer Page Contents International wash code symbols Care and cleaning Packaging materials Old machine Ecological hints General safety Safety informationPrior to using for the first time Use InstallationKeep all detergents in a safe place out of children’s reach Child SafetyDetergent dispenser drawer Product descriptionFirst Use Control panelChild safety lock Acoustic signalsPersonalization Daily UseSelect the required programme Measure out the detergent and the fabric softenerDetergent required, pour it into the main If required, pour fabric softener intoTo empty the water out Select the spin speed or the rinse hold optionProgramme option button Select the Stain option Select the Prewash optionSelect the Time Saving option DisplayProgramme progress display Select the Start/PauseSelect an additional rinse Cancelling a programmeAltering an option or a running programme Interrupting a programmeAt the end of the programme Washing programmes Refresh Pumpen VidangeSpin reduction Off Aus/ Arrêt White and fastEasy Iron Programme informationPreparing the wash cycle TemperaturesSorting out the laundry Before loading the laundryMaximum loads Laundry weightsFollowing weights are indicative Detergents and additives Removing stainsDegrees of water hardness Quantity of detergent to be usedPowder detergents for delicate fabrics 60C max and woollens Marked before starting the wash programmeEnergetic wash Delicate wash International wash code symbolsCare and cleaning Drain pump Washing drumDoor seal Care and cleaning Emergency emptying out Water inlet filterFrost precautions Something not working Possible cause/SolutionSomething not working Cause possible/Solution Door included Techinical DataConsumption value Unpacking InstallationHEC0003 HEC0023 C Connect the hose with the angled connection to the machine Positioning and levellingWater inlet Water drainage Water-stop deviceEnd of the drain hose can be positioned in three ways Drain hose must not be kinkedConnect the machine to an earthed socket Electrical connectionPermanent connection Packaging materials Enviroment concernsOld machine Ecological hintsChapter Repetition 132 966 340 -00-472007 Subject to change without notice