INSTALLATION
Attaching the water supply hose to the faucet
If you attach the water supply hose completely, it may cause a water leakage.
Faucet shape | |||
Square | Movable | ||
shaped | faucet | faucet | faucet |
The distance is needed 1.6 cm or more
Caution
•The old inlet hose should not be reused.
•If the faucets are not suited, please contact your dealer.
•Do not connect the hot water supplying convenience.
•In order to provide a permanent source of water for your washing machine, it is suggested that a branching water pipe (available separately) be used.
Attaching the hose union
1 Push the lock lever of the water |
supply hose. Pulling the sleeve down, |
lower the entire hose to disconnect |
Hose Union
5 Remove the seal from the union and turn to the arrow destination the nozzle to tighten securely.
the hose union. |
2 Check the diameter of the faucet. |
When the faucet mouth is large, |
loose the screws and remove the |
Lock lever
Water supply hose
Sleeve
6 Check the gap is approx. 1 to
3 mm between the nozzle and the ring.
• If the gap is wide, it may cause the water leak. |
| inside ring to facilitate, attachment. |
3 | Loose 4 screws of the hose union, |
| push the hose union to the water |
| faucet. |
4 | Tighten the four screws evenly |
| around the faucet. In this time check |
| the gap is approx. 4 mm between the |
| nozzle and the ring. |
Inside ring
Ring
Approx. 4 mm.
Joint seal
• If it cause the water leakage during operation, |
tighten the nozzle more securely.
Caution
•If you attach the hose union again because of moving house etc., loose the gap is approx. 4 mm between the nozzle and the
ring. Then attach it according
above methods. They are | Approx. | |
4 mm | ||
preventable the water leakage. | ||
|
Connecting the water supply hose
1Pull the sleeve down, then insert the water supply hose.
2Separate the sleeve until a click is heard, then push it up.
3Check to ensure that the lock lever is hung on the nozzle. Next, check to ensure that the water supply hose does not come off by pulling down on it.
Lock lever
4Tighten the hose nut on the end of the
water supply hose securely to the water
Nozzle | intake valve. | |
Sleeve | Hose nut | Water supply |
| ||
hose
Water intake valve
Caution:
•Check to ensure that the water supply hose is properly installed by turning the water on and checking for leakage.
If there is leakage, connect it from the first.
•If you remove the water supply hose after supplying water, water may splash. Refer to the following
— "Removing the water supply hose".
16