Description and Operation of Panel Parts

DESCRIPTION AND OPERATION OF PANEL PARTS

CHILD PROOF MODE DISPLAY

•Check this to see if the CHILD PROOF mode is ON (lit) or warning (flashing).

“PRESET” button

•You can set/reset the CHILD PROOF mode.

•You can set the time until washing finished.

“SUPER SPIN DRY” button

PROCESS DISPLAY

•Operating process is indicated by flashing. Remaining process is indicated by lightening.

“COURSE” button

•You can select the program suitable for the laundry.

“SELECT” button

•Select either the WASH, RINSE, or SPIN cycle as you desire.

“START/HOLD” button

•Press this pad when you want to start.

•Press this pad when you want to hold.

“POWER” button

•Press this button to power off/on.

•Power is automatically turned off about 15 seconds after the end of operation, or about 10 minutes later if the operation is not on.

WATER LEVEL

Auto-Set Mode

•	The water level is set linearly by adjusting
	to the washing volume. If the water level is
	assigned at the point with no particular
•	indication, then the nearest level lights up.
•	In this auto-set mode, the set water level

DETERGENT GUIDE

•The amount of supply using the measure spoon accompa- nying the compact detergent is displayed.

One spoonful of detergent denotes about 40L of water consumption

Depending on the kind of detergents, amount of water con- sumption by one spoonful changes. Adjust the detergent volume according to the particular detergent in use.

•	illuminates when water supply finishes.
	By pressing the "START/HOLD" button
	while water is in the wash basket, the
	highest water level lights up.
	Button Setting
•	By pressing the		button, a desired
•	water level can be obtained.
	Illumination shifts to the direction where
	the higher water level is indicated as the
	result of pushing the		button.
•	While using the "tub cleaning" program,
	the water level will be automatically at
	High and the	button cannot be used.

If you wish to turn off the end buzzer sound

•You can turn off the buzzer sound.

With pressing

Press

•With pressing "COURSE" button, press to turn on the power switch.

After buzzer beeps 3 times, the end buzzer disabled.

•As you reset, set the same way.

∗Once you set it, the washing machine will remember the mode set, and no need to set each time.