Smeg WDI16BA instruction manual Drying Instructions, END of Programme Beeper, General

Page 22

GB

To continue draining and spinning, press the spin select button twice. The machine resumes the cycle by draining the water and spinning. To select spin speed, press the button until the required speed is display ed. If you wish to drain the water in the tub without spinning, press the spin select button until 0000 appears on the display. This in- dicates that the machine will drain the water without spinning.

5.14 END OF PROGRAMME BEEPER

When a washing and/or dry ing cycle f inishes, the message END appears on the display and a beepers sounds twice. To disable this signal, press the second and third button f rom the left simultaneously. The message OFF immediately appears on the display to indicate that the beeper has been disabled.

To enable the end of programme beeper, repeat the operation. This time, the message ON will appear on the dis- play.

The appliance is supplied with the end of programme beeper enabled.

6. DRYING INSTRUCTIONS

6.1 GENERAL

The washing is dried by means of a continuous f low of hot air produced by a fan which passes through the drum and remov es humidity from the washing.

This humidity is then condensed inside the machine when it comes into contact with the cold water.

For this reason, the water tap must be left open and the drain hose must be correctly positioned during drying cycles.

This machine allows wash-only, dry -only and wash+dry programmes to be set.

In the latter programmes, the cycle shifts automatically f rom washing to dry ing without having to touch the controls to continue the cycle after washing.

Warnings

Only dry linen or garments washed in a water-based solution and suitable f or tumble drying.

Do not dry f abrics that hav e been dry -cleaned or stain-remov ed with chemical solv ents, woollens or

blended woollens that shrink with heat, v ery delicate f abrics such as silk and synthetic net curtains, f ab- rics that can easily fray such as loose wool, padding and excessively fray ed carpets, articles containing f oam rubber or similar elastomers.

The quantity of washing that can be introduced into the washer dryer for drying must not exceed 2.5kg. This washer dry er has been built to offer maximum performance with dry loads weighing not more than 2.5 kg.

When intensiv e washing programmes are set, drying is automatically performed at 90°C, while dry ing times may vary f rom 20 to 120 minutes.

For delicate programmes, dry ing is automatically perf ormed at 60°C, again with dry ing times v arying from 20 to 120 minutes.

22

Image 22
Contents Integrated Washer Dryer Contents NEW Washing System Safety Warnings Sibility for uses other than those described aboveProlonged inactiv ity AnceInstallation Instructions UnpackingAdditional Important Installation Instructions Water Supply ConnectionDrain Connection Electrical ConnectionFitting the Furniture Doors Use of the furniture door fixing template Fitting the hinge components to the furniture doorRecessing the appliance Fitting the plinthControl Panel Description of ControlsOpen door button ON-OFF and programme selection knob Time remaining Select the drying programmeSpin speed Error codesLED End of cycle ENDTion for heating increases Options enabled LEDs Detergent TrayPreparing the Washing Washing InstructionsOpening the Door Loading the Washing Adding Detergent and Additiv ESDosing Liquid Detergents Dosing Powder DetergentsSCALE-REMOV ERS Modifying Starting Param Eters OptionsInterrupting or Changing the Washing Programme Turn the programmes knob to OFF to switch off the machineStarting the Washing Programme END of ProgrammeEND of Programme Beeper Drying InstructionsGeneral WASH+DRY Programmes WASH-ONLY Programmes5kg DRY-ONLY Programme ExampleEND of Drying Programme Interrupting or Changing the Drying ProgrammeProgramme Finished Buzzer Cleaning the Drum Cleaning and MaintenanceExternal Cleaning Cleaning the Door GasketCleaning the Detergent Tray Cleaning the Water Inlet FilterTroubleshooting Error Signals Programs Control Panel SymbolsSection Temperature Programme Guide KEY to Button