Error Signals

	GB

11	The machine does not spin The unbalanced load sensor has triggered because the washing is not
	unif ormly distributed inside the drum. If the washing is wet at the end of

the cycle, distribute it well inside the basket and repeat just the spin cycle.

12Draining water from the drum

13The washing has not been correctly spun

14Residues of detergent on the washing

15The washing does not dry

16Washing results are unsat- isfactory

In the event of a power f ailure or a fault in the appliance, the water inside the drum can be drained as described in paragraph 6.3

Large items have rolled up and are not unif ormly distributed inside the drum. Always wash large items together with small ones.

Many phosphate-f ree detergents contain substances that are difficult to dissolv e in water.

Select the Rinse programme or brush the washing. Check that:

-the water tap is open

-the washing does not weight too much

-the dry ing time is suitable.

-suff icient dry ing time has been selected

If the machine does not dry all the same, call the Serv ice Centre to re- mov e fabric f rays f rom the fan and dry ing ducts.

-Too little detergent or an unsuitable detergent may hav e been used.

-Stubborn stains were not pre-treated

-The wrong temperature was selected

-The drum was overloaded

In the ev ent of faults, the machine will display an error code.

Problem

Door not closed properly. Close it.

Aquastop. Contact the nearest Serv ice Centre after disconnecting the machine from the electrical power supply and closing the water tap.

No water for washing. See point 2 on the troubleshooting table.

The water does not drain. See point 4 on the troubleshooting table.

For all other error codes, contact the nearest Assistance Centre after disconnecting the power supply and closing the water tap.