Smeg 129316 manual Drying procedure

Drying procedure	• Press the START/PAUSE button (D) - LED E is
		on, appliance starts to operate (after a 2 second
		pause).
	• 10 minutes prior the end of drying program the
		machine starts the cooling cycle (heater is off),
		which prevents excessive creasing.
	• At the end of the cooling program the appliance
		switches on the anti-crease program, which lasts
		for 1 hour (periodic tumbling of the drum); LED (E)
		is flashing.
	• If you open the dryer door the anti-crease
		program is suspended.
	- End of drying
		At the end of drying LED (E) flashes,
		which means that the drying program
		is completed. LED (F) is on, which for
		the evacuation type of dryer requires
		cleaning of filter, and for the condensation
		type cleaning the filter and draining the
		container.
	• Open the dryer door by pushing the left-hand side
		of the door towards the appliance.
	• Remove the laundry from the dryer.
	• Turn the appliance off by turning the jog selector
		(A) to the position “0”.
	• Clean the lint filter (see chapter on Cleaning and
		Maintenance).
	• Close the dryer door.
	• Empty the water container (this applies for
		condensation dryers only - see Cleaning and
		Maintenance) and replace it back to its slot.
	• Pull the power lead from the socket, disconnecting
		the appliance from the mains.

129316

12