Install the water inlet hose

1.Respectively attach the water inlet hoses to the hot water faucet and the cold water faucet. Using pliers, tighten the coupling. ( As figure 1)

NOTE: Do not over tighten. Damage to the valves can result.

2. Connect the hot and cold water inlet hoses to the hot and cold
water faucet.	Figure 1

3.Connect the other ends to their respective cold and hot water inlet valve located at the rear of the washer

Jointer of the water inlet hose

C C

H H

Jointer of the

water inlet valve Water absorption cushion

Note:

Figure 2

Hot water needs to be at a temperature of at least 120 F- 140 F. (49 C-60 C)for the soap to dissolve and to avoid soap residue remaining on clothes.

Check the connection between the water inlet hose and the water tap

1.Swaying the hose gently to confirm if it is fastened stable. 2.After installation, open the tap to check if it leaks. 3.Do not bend the hose with overstrain. 4.Before each usage please check if the connection between the water inlet hose and the water tap, is firm, so as to prevent dropping from improve Installation position.

Take down the water inlet hose

1.Close the water tap.

2. Pull off the water inlet hose from the water tap and washer