Smeg K400TL Water inlet hose filter, Check and clean regularly at least two or three times a year

Page 11

6GB10055.fm Page 11 Monday, August 2, 2004 12:33 PM

Water inlet hose filter

Check and clean regularly (at least two or three times a year).

1.Unplug the washing machine.

2.Turn off the tap.

3.Unscrew the hose from the tap.

4.Carefully clean the filter located at the end of hose, without assembling it, for example with a tooth-brush.

Note: For machines equipped with hose type “A”, it must not be submerged in water.

5.Screw the flexible hose back onto the tap by hand. Do not use pliers (risk of squashing the joint).

6.Turn on the tap and check that the connections are water- tight.

7.Plug the washing machine back in.

Recovering an object that falls between the drum and the tub

If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades:

1.Unplug the washing machine.

2.Remove the laundry from the drum.

3.Close the drum flaps and turn the drum a half-turn.

4.Using the screwdriver press the plastic end while sliding the blade from left to right.

5.It will fall into the drum.

6.Open the drum: you can recover the object through the hole in the drum.

7.Refit the blade from inside the drum:

Position the plastic tip above the hole on the right side of the drum.

8.Then slide the plastic blade from right to left until it clips.

9.Close the drum flaps again, turn the drum through half a turn and check the positioning of the blade at all its anchorage points.

10.Plug the washing machine in again.

A

3

4

4

7

GB 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Contents Remove the transport bracket Before Using the Washing MachineInstall the washing machine Remove the packaging and check Electrical connectionFirst Wash Cycle Precautions and General RecommendationsSort the laundry Description of the Washing MachinePreparation of the Washing Starching Stain removalDyeing and bleaching Open the machine lid Loading the laundryChoice of the right detergents and additives Detergents and AdditivesDosage Filling up with detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterWater inlet hose filter Check and clean regularly at least two or three times a yearWashing machine stops during the programme Water inlet hosesWashing machine does not start, no lamp lights up Washing machine does not start, but the pilot lamp is onWater Stop fault may have been triggered by Water stop fault depending on modelSpecify Before contacting After-Sales ServiceRemoval of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Fuse replacementValid Only For Great Britain And Ireland GB K 400 TL No spin button Programme Temperature Load Water EnergyMin Terminate the Rinse Hold option
Top Page Image Contents