Smeg K400TL manual Loading the laundry, Open the machine lid

Page 6

6GB10055.fm Page 6 Monday, August 2, 2004 12:33 PM

Loading the laundry

1.Open the machine lid.

2.Open the drum by pressing the button and keep your second hand on the big drum door at the same time.

3.Place the items of laundry in the drum one by one without compressing them. Follow loads recommended in the “Programme chart”: Overloading will result in unsatisfactory washing results and creased laundry.

4.To close the drum, please hold both doors in the middle again.

Attention: Make sure that the drum door flaps are properly locked, so that the button protrudes out beyond the edge of the big door flap.

1

2

3

GB 6

Image 6

Contents Contents Remove the packaging and check Electrical connection Before Using the Washing MachineInstall the washing machine Remove the transport bracketPrecautions and General Recommendations First Wash CycleDescription of the Washing Machine Preparation of the WashingSort the laundry Stain removal Dyeing and bleachingStarching Loading the laundry Open the machine lidFilling up with detergents and additives Detergents and AdditivesDosage Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Draining Residual Water Detergent dispenserCheck and clean regularly at least two or three times a year Water inlet hose filterWashing machine does not start, but the pilot lamp is on Water inlet hosesWashing machine does not start, no lamp lights up Washing machine stops during the programmeWater stop fault depending on model Water Stop fault may have been triggered byBefore contacting After-Sales Service SpecifyRemoval of transport bracket Adjust the feet Connect the water inlet hoseWater stop anti-flooding system Connect the water drain hoseFuse replacement Valid Only For Great Britain And IrelandPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A GB K 400 TL Terminate the Rinse Hold option Programme Temperature Load Water EnergyMin No spin button