Smeg K400TL manual Installation, Removal of transport bracket

Page 15

6GB10055.fm Page 15 Monday, August 2, 2004 12:33 PM

INSTALLATION

The washing machine is fitted with a transport bracket to avoid any possible damage during transport.

Before using the washing machine, the transport bracket at the back MUST be removed.

1.Unscrew the two screws A and the four screws B with a flat screwdriver or a No. 8 hex nut box spanner.

2.Remove the transport bracket.

3.Replace the four outer screws B on the machine and tighten them.

4.Remove the two seals C from the hose holder and clip them into the openings of the machine D.

Note: do not forget to replace and tighten the four outer screws.

GB 15

Image 15

Contents Contents Remove the transport bracket Before Using the Washing MachineInstall the washing machine Remove the packaging and check Electrical connectionFirst Wash Cycle Precautions and General RecommendationsDescription of the Washing Machine Preparation of the WashingSort the laundry Stain removal Dyeing and bleachingStarching Open the machine lid Loading the laundryChoice of the right detergents and additives Detergents and AdditivesDosage Filling up with detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterWater inlet hose filter Check and clean regularly at least two or three times a yearWashing machine stops during the programme Water inlet hosesWashing machine does not start, no lamp lights up Washing machine does not start, but the pilot lamp is onWater Stop fault may have been triggered by Water stop fault depending on modelSpecify Before contacting After-Sales ServiceRemoval of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemFuse replacement Valid Only For Great Britain And IrelandPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A GB K 400 TL No spin button Programme Temperature Load Water EnergyMin Terminate the Rinse Hold option