6GB10055.fm Page 17 Monday, August 2, 2004 12:33 PM
Water stop anti-flooding system
(depending on model)
•Screw the hose to the water supply tap. Turn the tap fully on and check the
•The washing machine must not be connected to the mixing tap of a
•The inlet hose and the plastic enclosure contain (depending on model) electrical components: do not cut the hose and do not immerse the enclosure in water.
•If the flexible hose is damaged, unplug the washing machine from the mains immediately, turn off the tap and replace the hose.
If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from
Connect the water drain hose
1.Unhook the drain hose from the left and right hose connections, see arrow A in figure.
Important:
Do NOT loosen the drain hose connection from the right side, see arrow B in figure. Otherwise, there is the risk of leakage and of scalding with hot water.
2.Fix the “U” bend (C) to the free end of the drain hose.
A
C
3.Connect the drain hose to the siphon or hook it over the
edge of a sink with the “U” bend.B Small hand basins are not suitable.
The edge of the sink must be no more than 100 cm from the floor.
If you need to add an extension, use a flexible hose of the same size and secure the unions with
Maximum drain height (“U” bend): 100 cm.
Minimum drain height: 55 cm.
Important:
Make sure there are no kinks in the drain hose and take precautions against it falling while the washing machine is running.
GB 17