6Quick instructions for daily use
Preparation
1.Turn the tap on completely. Check if the hoses are connected tightly.
2.Place the laundry in the machine.
3.Add detergent and softener.
Starting
1.Press the “On/Off” button.
2.Select the programme and the temperature.
3.If required (according to your machine’s model):
–select any auxiliary function,
–adjust the spin speed,
–set the time delay,
4.Close the loading door.
5.Press Start/Pause/Cancel button.
Canceling a program
•Press “Start/Pause/Cancel” button for 3 seconds. The machine starts to discharge the water. “Wash” and “Program Finished” lights will light up.
•“Start/Pause/Cancel” and “Wash” lights will go off after discharging process is over and the “Lid” light will start flashing.
•If the program is cancelled in the middle of the process, “Wash” and “Program Finished” lights will light up. The machine can drain all the water or can take in water for 3 times at most to cool down the clothes and complete draining process. When water discharging process is completed, “Wash” light will go off, “Program Finished” light will light up and the “Lid” light will continuously flash until the door is allowed to be opened. You can make a new program selection when the “Lid” light is lit continuously.
Adding more laundry
You may add more laundry into the machine at the beginning of washing.
CMachine allows adding more laundry during a later step only if the water
level is low enough to open the loading door or if the temperature in the machine is low enough.
In order to add laundry after the
1.Press Start/Pause/Cancel button.
Wait until the door is allowed to open. “Lid” lamp will light up continuously when the door is allowed to open.
2.Open the loading door and put in more laundry.
3.Close the loading door.
4.Press Start/Pause/Cancel button.
Program is in rinse hold mode
CAfter the machine fills with water in the final rinse step, clothes can be soaked in the machine as long as desired.
When it reaches this position while the machine is running, the “Start/Pause/ Cancel” light will flash.
In the machines equipped with spin speed selection knob, you can spin by selecting the desired spin speed and press “Start/Pause/Cancel” button. As for machines not equipped with a spin speed selection knob, you can end the program without spinning by pressing the “Start/Pause/Cancel” button to drain the water. You may spin your clothes whenever you wish to by selecting the spin program.
Re-spinning the laundry
The control system for an unbalanced load can pause the spinning in cases when the distribution of the laundry in the drum is not balanced.
If you want to
1.Rearrange the previously placed clothes in machine.
2.Select Spin+Pump program.
21
EN