Beko WM 5100 S manual

place.

If your product is not supplied with an emergency drain hose, do the following as shown in the figure below:

•Place a large container in front of the filter to receive water flowing from the filter.

•Loosen pump filter (anticlockwise) until water starts to flow out of it. Direct the flowing water into the container you have placed in front of the filter. You can use a piece of cloth to absorb any spilled water.

•When there is no water left, turn the pump filter until it is completely loose and remove it.

•Clean any residues inside the filter as well as fibers, if any, around the propeller region.

•If your product has a water jet feature, be sure to fit the filter into its housing in the pump. Never force the filter while replacing it into its housing. Fit the filter fully into its housing; otherwise, water may leak from the filter cap.

4- Close the filter cap.

Close the two-piece filter cap of your product by pushing the tab on it.

Close the one-piece filter cap of your product by fitting the tabs on the bottom into their positions and pushing the upper part of it.

25

EN