Beko D2 7102 E End of program, Ending the program through canceling, Program in rinse hold mode

on the screen whenever any button is pressed while the machine is child-

locked.

To deactivate the child-proof lock, press the 2nd and 4th auxiliary function buttons for 3 sec.

“C:OFF” (Child lock is deactivated) label

appears on the screen.

without spinning:

Press “Start/Pause/Cancel” button (Figure 2-8). Standby symbol (Figure

3-2k) will fade. Start symbol (Figure 3-2j) will light up. The program continues and only pumps out the water.

End of program

When the program is finished, the symbols of the relevant steps will remain lit up and the auxiliary function, spin and temperature data selected at the start- up of the program will remain selected. “End” label will appear on the screen.

Ending the program through canceling

“Start/Pause/Cancel” button (Figure

2-8) is pressed for 3 seconds to cancel the program. Start symbol (Figure 3-2j) will flash during cancellation. After cancellation, the symbol of the corresponding step at which the cancellation was made will remain lit and

“End” label will appear on the screen.

Program in rinse hold mode

•This process is shown with the flashing Spin Symbol (Figure 3-2c) and the lit up Standby Symbol

(Figure 3-2k).

If you wish to spin when the machine is in this mode:

Adjust the spin speed. Press “Start/ Pause/Cancel” button (Figure 2-8). The program continues, pumps out the water and spins. Standby Symbol (Figure 3-2k) fades out and Start Symbol (Figure 3-2j) lights up.

If you want to discharge the water only

22

TR