6Quick instructions for daily use
Preparation
1.Turn the tap on completely. Check if the hoses are connected tightly.
2.Place the laundry in the machine.
3.Add detergent and softener.
Starting
1.Press the “On/Off” button.
2.Select the program and the temperature.
3.If desired (according to your machine’s model):
–select any auxiliary function,
–adjust the spin speed,
–set the time delay,
4.Close the loading door.
5.Press “Start/Pause/Cancel” button.
The display shows the time remaining for the program to complete if time delay is not set.
The display shows the time remaining for the program to start if the time delay is set.
6.Check if the Door Locked Symbol lights up on the screen.
The Door Locked Symbol (Figure
The Door Locked Symbol (Figure
Cancelling a program
1.Press and hold the “Start/Pause/ Cancel” button for about 3 seconds; the Start symbol will start flashing.
2.The machine can discharge all the water or can take in water for 3 times at most to cool down the clothes and complete discharging process.
Adding more laundry
•This is only possible under the following conditions:
–during time delay,
CYou may add or remove laundry during the time delay (until the
program starts). At the beginning of a washing cycle (machine allows adding more laundry during a future step only if the water level is low enough to open the loading door or if the temperature in the machine is low).
In order to add laundry after the
1.Press “Start/Pause/Cancel” button.
2.Open the loading door and put in more laundry.
3.Close the loading door.
4.Press “Start/Pause/Cancel” button.
Program is in rinse hold mode
CThis process is shown with the flashing spin symbol and the standby symbol which is lit up.
If you wish to spin when the machine is in this mode:
1.Adjust the spin speed.
2.Press “Start/Pause/Cancel” button.
The program continues, pumps out the water and spins.
3.The standby symbol fades out and the start symbol lights up.
If you want to discharge the water without spinning:
1.Press “Start/Pause/Cancel” button.
2.The standby symbol fades out and the start symbol lights up.
3.The program continues and only pumps out the water.
Re-spinning the laundry
The control system for an unbalanced load can pause the spinning in cases when the distribution of the laundry in the drum is not balanced.
If you want to
1.Distribute the laundry in your machine for a balanced load.
2.Select the spin program.
3.Adjust the spin speed.
23
TR