Operating Instructions
Washing Cycle Complete/Removing the Washing
The washing program normally ends with the final spin.
After a rinse hold:
After a rinse hold the water must first be pumped out or the washing spun:
0 1. Release the (RINSE HOLD) button.
2.Either turn the program selector clockwise to position 6 (SPIN), or position 8 or 11 (SHORT SPIN)
(the washing is spun according to the selected program and the spin speed set)
or
turn the program selector clockwise to v (PUMP OUT) (the water is pumped out).
Once the program is finished:
3For safety reasons, the door remains locked for
0 1. Open the door.
2.Remove the washing.
3.Press the M (ON/OFF) button.
The indicator extinguishes, the washing machine is switched off.
4.Close the water tap.
5.Pull out the detergent dispenser drawer a little so that it can dry out. Leave the door ajar for a while. This helps to prevent stagnant smells and helps to preserve the door seal.
Important! If the washing machine is not to be used for a long period: close the water tap and isolate the washing machine from the mains.
22