Rinse hold: when you choose this option, the machine will not drain the water of the last rinse, this will ensure the minimum of creasing to laundry.
At the end of the cycle, the lights corresponding to the options “Rinse hold” and the “Door lock” are on, the “Start/Pause” button light goes out and the display shows a flashing «0».
The door cannot be opened because the water must be drained.
To empty out water there are 2 possibilities:
-Select Drain programme and press the
“Start/Pause” button : the water is emptied out without spinning.
-Select Spin programme. Select the spin speed by pressing the relevant button and then press the Start/Pause button. The water is emptied out and the laundry is spun at the selected spin speed.
Attention!
Before selecting Drain programme or Spin programme the selector dial must first be turned to the «Off» position.
STAIN: Select this button if you wish to add a stain phase to the washing of heavily soiled laundry. Pour a stain removing detergent into the compartment
marked .
This function is available for programmes with a temperature of 40° or higher.
The washing time will be prolonged by a few minutes. For the compatibility of this option with the washing cycles, refer to the Chapter «Washing programmes»
4 Prewash button
Select this option if you wish your laundry to be prewashed before the main wash.
The prewash ends with a short spin in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained. This option can be selected for heavily soiled laundry.
5 Quick button
This option can be used for lightly soiled garments in order to obtain a good washing programme in a short time. The washing time will be reduced according to the type of fabric and the selected temperature.
We recommend that you reduce the load to 3 kg for Cottons and 1.5 Kg for Synthetics and Delicates.
For the compatibility of this option with the washing cycles, refer to the Chapter «Washing programmes»
6 Extra rinse button
This option can be selected with all programmes, except the Wool programmes and “30 Minute wash”. The machine performs some additional rinses.
This option is recommended for people who are allergic to detergents, and areas where the water is very soft.
7 Display (Wash time)
The following pieces of information are shown on the display:
●Duration of washing programme in hours and minutes, after you have selected a programme.
| While the programme is | |
2.00 | running (after you have | |
pressed the Start/Pause | ||
|
button), the displayed time value decreases by one unit every minute.
●The washing machine has completed the programme: this is indicated by a flashing zero. The “Door lock” pilot light and the Start/Pause light go out and the door can be opened.
●The washing machine has stopped with water in the tub, at the end of the “Soak” or of a programme with the “Rinse hold” option: this is indicated by a flashing zero. The Start/Pause light goes out but the “Door lock” pilot light is still on. The door cannot be opened.
| If your laundry is not | |
0 | removed within 10 minutes | |
after the programme has | ||
|
finished, all pilot lights and the display switch off and the energy saving system
will be enabled. Only the green Start/Pause light flashes to indicate that the appliance has to be switched off.
●Delay start, a time value indicated in hours and selected by means of the relevant button.
The delay time (20 hours max) is displayed for a few seconds, then the duration of the selected programme reappears.
After you have pressed the
Start/Pause button, the countdown is updated every hour, and, for the last hour, every minute.
●An incorrect option selection has been made:
7