Husqvarna DWF-8089, DWF-7589 instruction manual Inlet Hose Connection, For Ordinary Tap

6

INLET HOSE CONNECTION

Be careful not to confuse hot water inlet and cold water inlet.

In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet valve.

For Ordinary Tap

1Pull down the collar of	2Loosen the four screws	3Fit the water tap adapter
the inlet hose to separate	properly in fitting into	into the water tap tap
it from the water tap	water tap.	and tighten the four
adapter.		screws evenly while
		pushing up the adapter
		so that the rubber
		packing can stick to the
		water tap tightly.

		TAPE
4Remove the tape, and	5Connect the inlet hose to	6Connect the inlet hose
screw connector B into	the water tap adapter by	adapter of the hose to
connect A tightly.	puling down the collar of	the water inlet of the
	the hose end.	washer by turning it
		clockwise to be fixed
		tightly.

Connector A

Connector B

• Please check the rubber packing inside the inlet hose adapter of the hose.

For Screw-Shaped Tap

1Connect the inlet hose to the water tap by screwing the connector tightly.

Rubber

ConnectorPacking

2Connect the connector- inlet supplied if necessary.

Connector inlet

Rubber

ConnectorPacking

3Insert the inlet hose adapter into the water inlet of a washer and turn it to be fixed.

Hose Connector

Hose Connector

*Cheek the packing in the inlet

6