Husqvarna DWF-8089, DWF-7589 instruction manual Functions of the Control Panel, Cold COLD+HOT HOT

` 8

THE FUNCTIONS OF THE CONTROL PANEL

WASH TEMP.	DETERGENT	FUZZY			RINSE
			REMAIN
	HIGH
HOT						POWER
	MEDIUM	BLANKET
COLD	LOW	ECONOMY	MIN.	WASH	CONTROL	SPIN
					ONLY SPIN
						START
	SMALL	SUIT	RES.
		SOAK			SPRAY RINSE	HOLD
WASH	WATER
TEMP.		COURSE	RES.		PROCESS
	LEVEL

POWER • Press this switch to turn the power on or off.

•It can be used to choose water temperature to be supplied.

•As the button is pressed, water temperature will be repeated.

WASH	COLD ➝ COLD+HOT ➝ HOT
TEMP.
	• In case of the single valve model, there is no wash temperature
	selector function.
	• It can be used to adjust amount of water according to the size of the
WATER	load to be washed.
	• As the button is pressed, water level is selected by
LEVEL
	MEDIUM ➝ HIGH ➝ SMALL ➝ LOW
RES	• It can be used to pre-engage time for wash.
PROCESS	• It is the button for the partial process or the combination of each
	process (wash, rinse, spin) (See page 10)

•If you want to change wash time, rinse times, spin time, you must

CONTROL	press this button after selecting each process by the process button.
ONLY SPIN
	Also, this button can be used to spin only. (See page 10)

•It can be used to select the full-automatic course.

COURSE	• As the button is pressed, course will be selected by following order:
	FUZZY ➝ BLANKET➝ ECONOMY ➝ SUIT(WOOL) ➝ SOAK

•Operation and temporary stop is repeated as it is pressed.

START/	• When you want to change course in operating;
HOLD	press the "START/HOLD" button ➝ Select the course that you want to
	change ➝ press the "START/HOLD" button again.

8