` 5
Non-Pump Model
1In case that it goes over a door sill.
Don’t let the height of the drain hose exceed 20cm from the bottom of washer.
20Cm
2In case of extending the drain hose.
Don’t let the total length exceed 3m.
3m
3Be careful that the end of the drain hose is not immersed in water.
Pump Model
Laundry tub drain system | Standpipe drain system |
• Top of tub must be at least 86cm | • Needs a 3cm minimum diameter |
(34inches) high and no higher than 130cm | standpipe with minimum carry away |
from bottom of washer (A) | capacity of 30liters per minute. |
| • Top of tub must be at least 86cm |
| (34inches) high and no higher than 130cm |
| from bottom of washer (B) |
A |
|
| B |
ELECTRICAL REQUIREMENTS
WARNING
electrical shock hazard: failure to follow these instructions could result in death or serious injury.
•Electrical earth is required on this washer
•If it does not fit the outlet, have a proper outlet installed by a qualified electrician.
•Don’t earth to a gas pipe
•Don’t change the power supply cord plug.
•Check with a qualified electrician if you are not sure the washer is properly earthed.
Recommended earthing method
C
B
A
For your personal safety, this washer must be earthed.
This washer is equipped with a power supply cord (A) having a earthing plug (B). To minimize possible shock hazard, the cord must be plugged into a mating
If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have the proper earthed wall receptacle installed by a qualified electrician.
5