4.4Extra rinse symbol: it illuminates when the option is enabled.
4.5Cycle duration calculating symbol: when selecting the «proportional» programmes, the display shows the washing duration of the maximum recommended load. After the button 10 has been pressed, on the display the «Wash time» (4.7) starts blinking and the animated symbol appears to indicate that the appliance is calculating the laundry amount and the real duration. During this time, the washing duration shown decreases. When the calculating phase has finished, the «Wash time» stops blinking, the animated symbol disappears. The washing time is adjusted to the real load.
4.6The following pieces of information are shown on the display:
•Duration of washing programme in hours and minutes, after you have selected a programme. While the programme is running (after you have pressed the Start/Pause button), the displayed time value decreases by one unit every minute.
•Delay start, a time value indicated in hours and minutes and selected by pressing the delay start button. The delay time (20 hours max) is displayed for a few seconds, then the duration of the selected programme reappears. After you have pressed the button 10, the countdown is updated every hour, and, for the last hour, every minute.
•An alarm code indicates a fault with the machine (see the relevant chapter).
•An incorrect option selection has been made: this is indicated by the message Err for a few seconds when an option incompatible with the current programme is selected.
•The washing machine has completed the programme: this is indicated by a flashing zero. The «Door lock» pilot light (11) and the Start/Pause light go out. The door can be opened.
•The washing machine has stopped with water in the tub, at the end of the «Soak» or of a programme with the «Rinse hold» or «Quiet» option: this is indicated by a flashing zero. The «Start/ Pause» light goes out but the «Door lock» pilot light is still on. The door cannot be opened.
4.7«Wash time» message:
•on when the washing cycle starts and when the duration is shown on the display.
•off at the end of the cycle, and during the delayed start selection
•blinking during the time calculation if you
have selected a «proportional» programme.
4.8Quick message: it appears when the option is enabled.
4.9Delay Startmessage: it appears during the selection of the delay.
4.10Child lock symbol (see more details in the «Personalisation» chapter)
12