John Lewis JLWM 1410 Programme correction, Cancel a programme or switch the appliance off

Page 16

flashes 3 times and the message Err is displayed for a few seconds.

Important!

You must set the washing machine to Pause before you make any change in the programme in progress.

Programme correction

As long as the wash programme has not been started yet, the programme selection can still be changed.

If the programme has been started, it is only possible to correct the functions, if the programme is first interrupted by pressing button 10. In this case only some of functions can be selected depending on the programme which is running.

If the wash programme is to be corrected by means of buttons 3, the appliance must first be switched off by pressing the button 2.

Switch on the appliance, set the new programme and press button 10 again. The water remains in the tub.

Cancel a programme or switch the appliance off

If a washing programme that has already started is to be cancelled, press button 2 to RESET the programme. All lights and the display go out and the appliance is switched off. The previously selected programme is now cancelled. Another programme can now be selected.

Important! If any problems occur as the programme runs, always first switch the appliance off by pressing button 2 before a new programme is selected. Consider the temperature to which the washing water may already have been heated. Press the button 10 to interrupt a programme which is running, the corresponding green pilot light starts blinking.

How to interrupt a programme

Press the button 10 to interrupt a programme which is running, the corresponding green pilot light starts blinking.

Press the same button again to restart the programme.

How to open the door during the cycle of a programme

You can open the door, after having set the washing machine to Pause, provided the following conditions exist:

•The washing machine is not in the heating phase

•The level of the water is not high;

If these requirements are met, when you pause the washing machine, the «Door lock» light goes off and the door can be opened.

Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the appliance off by pressing button 2. After a few minutes, you can open the door.

Pay attention to the level and temperature of the water in the washing machine!

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Jlwm Spin washing machine Safety information General safetyInstallation UseChild safety Keep all detergents in a safe place out of children’s reachContents Page Rating plate Drain pump Adjustable feet Product descriptionDetergent dispenser drawer Control panel «On/Off» / «Reset» programme buttonProgramme selector buttons Temperature button SpinExtra Rinse QuickDelay Start Door lock lightDisplay Available options Easy ironExtra rinse symbol it illuminates when the option is enabled Following pieces of information are shown on the displayAcoustic signals First usePersonalisation Child lockSwitch the machine on and select the required programme Daily useLoad the laundry Measure out the detergentSelect the desired temperature and spin speed Select the delay startSelect the desired options Start the programmeCancel a programme or switch the appliance off How to interrupt a programmeHow to open the door during the cycle of a programme Programme correctionSwitch the appliance off by pressing button Helpful hints and tipsEnd of programme Sorting out the laundryBefore loading the laundry Removing stainsDetergents and additives Ball point pen and glue moisten withQuantity of detergent to be used Degrees of water hardnessWashing programmes EconomyWhite or fast colour cotton normally or slightly Synthetics1Lingerie Hand wash WoolRinse Duvet SpinMinute wash Consumption values Technical dataProgramme1 Energy consumption Water consumption KWh2 Litre2 Standard programmes for the Energy Label consumption values Care and cleaning Cleaning the drawer recess Cleaning the pumpWashing drum Door sealPage Cleaning the water inlet filters Frost precaution Clean the pump if necessary as previously describedEmergency emptying out Turn on the water tapInstallation UnpackingPositioning and levelling PlumbingWater-stop device Water inletOpen the porthole and extract the inlet hose Into a drainage standpipe Water drainageOnto a sink outlet spigot Special conditions Interest of the environmentElectrical connection Green and Yellow Earth Brown- Live Cord Clamp Blue- Neutral Appliance is supplied with a 13 amp plug fittedPermanent connection Problem Possible cause/Solution What to do if…Washing machine Does not startMachine does not fill Machine does notEmpty and/or does not Machine fills thanUnsatisfactory washing ResultsDoor will not open Machine vibratesRepairs After Sales Service Repairs After Sales ServiceYour appliance comes with a three year warranty Spare partsPackaging materials Environment concernsEcological hints Page Page 132945871-A-092011
Top Page Image Contents