Before you make any change, you must PAUSE the appliance by pressing the button
5.
Changing a running programme is possible only by resetting it. Turn the programme selector dial to Off and then to the new programme position. Start the new programme by pressing the button 5 again. The washing water in the tub will be not emptied out.
Interrupting a programme
Press the button 5 to interrupt a programme which is running, the corresponding green pilot light starts blinking.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to Off position to cancel a programme which is running. Now you can select a new programme.
Opening the door
After the programme has started the door is locked. If, for any reason, you need to open it, set firstly the machine to PAUSE by pressing the button 5 . After a few minutes the "Door lock" light goes off and the door can be opened.
If the door remains locked, this means that the machine is already heating or that the water level is too high. In any case, do not try to force the door!
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to Off position. After a few minutes the door can be opened (pay attention to the water level and temperature!) .
After closing the door, it is necessary to select the programme and options again and to press button 5 .
At the end of the programme
The machine stops automatically. The pilot light of button 5 goes off and after a few minutes the Door lock pilot light goes off. The light End illuminates. The door can be opened.
If a programme or an option that ends with water left in the tub has been selected, the light Door lock illuminates and the door remains locked to indicate that the water must be emptied out before opening the door. Follow the below instructions to empty out the water:
1.Turn the programme selector dial to Off .
2.Select the draining or spinning programme.
3.Reduce the spin speed if needed, by pressing the relevant button.
4.Press button 5 .
At the end of the programme, the door can be now opened. Turn the programme selector dial to Off to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
If your laundry is not removed during 10 minutes after the programme is finished the energy saving system is enabled. All options and cycle status pilot lights are turned off, only the button 5 pilot light is blinking to indicate that the appliance has to be switched off. By pressing any button the appliance will come out from the energy saving status and you
12