The washing machine has stopped with water in the tub, at the end of the «Soak» programme or if the «Rinse hold» option has been set: this is indicated by a flashing zero. The «Door lock» pilot light is still on. The door cannot be opened.
The washing machine has completed the programme: this is indicated by a flashing zero. The «Door lock» pilot light has gone off. It is now possible to open the door.
•Delay start, a time value indicated in hours and selected by the relevant button. The delay time (20 hours max) is
First use
displayed for a few seconds, then the duration of the selected programme reappears. After you have pressed the button 8, the countdown is updated every hour, and, for the last hour, every minute.
•An incorrect option selection has been made: this is indicated by the message Err for a few seconds when an option incompatible with the current programme is selected.
•An alarm code indicates a fault with the machine (see the relevant chapter).
•Ensure that the electrical and water connections comply with the installation instructions.
•Remove the polystyrene block and any material from the drum.
•Pour 2 litres of water into the main
wash compartment 
of the detergent drawer in order to activate the ECO valve. Then run a cotton cycle at the highest temperature without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the main wash compartment and start the machine.
11