1. Into a drainage standpipe
Firstly form a hook in the end of the drain hose using the “U” piece” supplied.
1
local Service Force Centre. The joining piece must have an internal diameter of 18 mm.
If your drain hose looks like this (see below) you do not require the “U” piece”. Just push the hose firmly in to the standpipe.
Place the drain hose into your standpipe, which should have an internal diameter of approximately 38 mm thus ensuring there is an air break between the drain hose and standpipe.
38 mm (½”) 
(12”)
cm30
When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level.
3 pin |
|
60 cm (23.6”) | Min. 90 cm (35.4”) |
Min. |
|
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the appliance. If you intend to drain the hose from the machine into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic “U - Piece” supplied.
31