If you have chosen a delayed start, the washing machine will begin the countdown.
The display will show the duration of the programme or the selcted delay.
Programme correction
As long as the wash programme has not been started yet, the programme selection can still be changed.
If the programme has been started, it is only possible to correct the functions, if the programme is first interrupted by pressing button 10. In this case only some of the following functions can be selected depending on the programme which is running: Spin reduction, No Spin, Rinse hold, Easy Iron, Extra Rinse and Quiet.
If the wash programme is to be corrected by means of buttons 3, the appliance must first be switched off by pressing the button 2.
Switch on the appliance, set the new programme and press button 10 again. The water remains in the tub.
Cancel a programme or switch the appliance off
If a washing programme that has already started is to be cancelled, press button 2 to RESET the programme. All lights and the display go out and the appliance is switched off. The previously selected programme is now cancelled. Another programme can now be selected
.
Note!
If any problems occur as the programme runs, always first switch the appliance off by pressing button 2 before a new programme is selected. Consider the temperature to which the washing water may already have been heated.
How to interrupt a programme
By pressing the button 10, a running programme can be stopped. The light in the button flashes.
The programme is continued by pressing the button again.
Opening the door after the programme has started
The door can be opened while a programme is running, if certain conditions are fulfilled:
•The washing machine is not in the heating phase beyond 55°C;
•The level of the water is not high;
If these requirements are met, when you pause the washing machine, the light 11 goes off and the door can be opened. If the light 11 remains lit, the door cannot be opened. In any case, do not force it!
Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the appliance off by pressing button 2. After a few minutes, you can open the door.
Pay attention to the level and temperature of the water in the washing machine!
When you close the door to restart the programme select the previous programme by pressing the buttons 3, repeat the options previously selected and press the button 10.
End of programme
The pilot light of the button 10 goes out. «0» blinks and the message Wash time disappears from the
The pilot light 11 goes out. The door can now be opened and the laundry can be removed.
Switch the appliance off by pressing button 2, before remove the laundry.
If the Rinse Hold or Quiet option has been selected the pilot light 11 is on, the pilot light of the button 10 goes out and the display shows a blinking «0».
The door cannot be opened because the water must be drained.
To empty out the water there are 2 possibilities:
•Select the draining programme and press the button 10 : the water is emptied out without spinning.
•Select the spinning programme. Select the spin speed by pressing the relevant button and then press the button 10. The water is emptied out and the laundry is spun at the selected spin speed.
Switch the appliance off by pressing button 2.
Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap and disconnect the plug from the socket. Leave the door open to prevent the formation of mildew and unpleasant smells.
11