John Lewis JLWM 1406 instruction manual Electrical connection

Page 26
- Earth
- Neutral - Live

SHOWER

 

 

SINK TOILET

BATH

BIDET

WASHING

DISHWASHER

MACHINE

RAINWATER

 

'RUN-OFF'

 

 

FOUL DRAIN

SURFACE WATER

FOUL SEWERS

DRAINS & SEWERS

 

 

SEWAGE

UNTREATED

TREATMENT

DISCHARGE

WORKS

 

TREATED

 

DISCHARGE

RIVER

RIVER

 

P0987

 

It is essential that these appliances are not connected

 

Mod

 

Prod. No

P0042 BD

Ser. No

 

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

Blue

Brown

GREEN & YELLOW

E

to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution.

N

13 A

L

If you require any further advice please contact your local water authority.

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Should the appliance power supply cable need to be replaced, this must be carried out by a Service Force agent (see page 27).

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the top of the rim of the open door.

BROWN

BLUE

P1041

CORD CLAMP

 

If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug.

Proceed as follows:

1.The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow.

2.The wire coloured blue must be connected to the terminal marked «N» or coloured black.

3.The wire coloured brown must be connected to the terminal marked «L» or coloured red.

4.Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely.

26

Image 26
Contents Jlwm Spin washing machine Use InstallationChild safety Ecological hints Maintenance and cleaning ServiceMaterials marked with the symbol are recyclable Environmental informationContents Control panel On/Off and Reset buttonTemperature button Door Lock pilot light Spin speed button Detergent dispenser drawerMulti-Display Spin speed indicator «Rinse hold» and «QUIET» optionsDisplay and buttons Extra rinse option«Temperature» button Acoustic Signal«On/Off» / «Reset» programme button «Programme selector» buttons«Extra rinse» button «Spin» button«Options» button «Quick» buttonDoor Lock pilot light «Delay start» button«Start/pause» button Select the Delay start option Switch the machine on and select the desired programmeSelect the desired temperature and spin speed Load the laundryEnd of programme Cancel a programme or switch the appliance offHow to interrupt a programme Programme correctionSheet Hints & tips on washing1000g = 1 kg Bath robeWash care symbols Important notesWashing programmes Lingerie, underwear Programme descriptionLoad Water drainingLightly soiled or which needs ItemsCan be used for laundry which is Freshening up Main wash rinses Spin atMaintenance and cleaning Remove any objects from the pump impeller by rotating it Cleaning the water inlet filterEmergency emptying out Screw the pump cover fully Close the pump doorSomething not working Spinning Green Start/Pause lightMachine vibrates when Door will not openDetergent dispenser drawer Child safety featureDescription of the appliance Prewash Main wash Fabric softener«COTTONS ECONOMY» at 60C InstallationTechnical specifications Positioning Installation on a suspended floorUnpacking PlumbingAppliance must be connected to a cold water supply Water inletWater drainage Into a drainage standpipeOnto a sink outlet spigot LevellingInterest of the environment Electrical connection Repairs After sales service Permanent connection132 961 34/08