Display and buttons
4.10 |
|
| 4.9 |
| |
| Quiet | Easy Iron | Delay start | 4.8 | |
Cold | Rinse hold | Intensive | Quick | ||
Wash time | 4.7 | ||||
|
| Stain | |||
|
|
|
| ||
|
| Prewash | Extra Rinse |
|
4.1 4.2 4.3
Multi-Display (4)
4.1Temperature indicator: the provided washing temperatures are 95° or 90°- 60°- 50°- 40° - 30°. Cold corresponds to cold washing.
4.2Spin speed indicator - «Rinse hold» and «QUIET» options
Note! The spin exclusion is indicated by a «0».
4.3Available options: Easy iron, Intensive, Stain and Prewash. The rectangle around an option appears when the option is selected, disappears when the appliance starts operating (after pressing button 10).
4.4Extra rinse option.
4.5Cycle duration calculating symbol: when selecting the «proportional» programmes, the display shows the washing duration of the maximum recommended load. After the button 10 has been pressed, on the display the «Wash time» (4.7) starts blinking and the animated symbol 4.5 appears to indicate that the appliance is calculating the laundry amount and the real duration. During this time, the washing duration shown decreases. When the calculating phase has finished, the «Wash time» stops blinking, the animated symbol 4.5 disappears and the washing time is adjusted to the real load.
4.6The following pieces of information are shown on the display.
•Duration of the programme in hours and minutes, after you have selected a programme (ex. 2.05). While the programme is running (after you have pressed the button 10), the displayed time value decreases by one unit every minute.
4.4 4.5 4.6
•The washing machine has completed the programme: this is indicated by a blinking zero (0). The «Door Lock» pilot light (11), the pilot light of button 10 go out and the door can be opened.
•The washing machine has stopped with water in the tub, at the end of a programme with the «Rinse hold» or «Quiet» option: this is indicated by a blinking zero. The light of button 10 goes out but the pilot light 11 is still on. The door cannot be opened. Note! If your laundry is not removed within 10 minutes after the programme has finished, all pilot lights and the display switch off and the energy saving system will be enabled. Only the green light of button 10 blinks to indicate that the appliance has to be switched off. By pressing any buttons the appliance will come out from the energy saving status and you could set another washing programme or switch off the appliance. The STAND BY status is incompatible with the «Delay start» option.
•Delay start, a time value indicated in hours (ex.15h) and selected by pressing button 12. The delay time (20 hours max) is displayed for a few seconds, then the duration of the selected programme reappears. After you have pressed the button 10, the countdown is updated every hour, and, for the last hour, every minute.
•An incorrect option selection has been made: this is indicated by the message «Err» for about a few seconds when a function incompatible with the current programme is selected.
•An alarm code indicates a fault with the machine (ex. E20, see the relevant chapter).
6