OPERATING INSTRUCTIONS
Other Features
Status Display/Status Lights
The estimated total cycle time will be displayed when the cycle is selected. The time may increase if water pressure is low, oversudsing occurs or the load becomes unbalanced. The approximate time remaining will be displayed during the cycle.
Oversuds Detection
A situation where oversudsing has been detected by the washer will result in the washer automatically adding extra rinses to attempt to clear the suds. Each extra rinse the washer performs to clear the suds will add 5 minutes to the cycle display time. If an excessive amount of detergent has been added and additional rinsing has not corrected the issue, “TOO MUCH DETERGENT” will be displayed.
Vent Latch
Help prevent odor buildup and mildew between washes by utilizing your washer’s vent latch feature. To apply the vent lock, (1) open the door slightly, (2) lift the latch arm and then (3) press the arm down onto the plastic door strike, snapping it in place.
The vent latch can be released either of two ways - by pulling door out and manually returning latch arm to lower position or by pushing door shut and allowing latch arm to continue its pivot upward.
IMPORTANT
Do not attempt to close door if vent latch arm is disengaged and arm is in an outward position. Return latch arm to lower position before closing and latching the door.
NOTE
The vent latch may become dislodged from hinge point if door closure is attempted while latch arm is not in an acceptable closing position. The latch arm can be snapped back in at the hinge location. Washer will still operate without latch arm installed.
STATUS DISPLAY
The following will also be displayed at the appropriate times during the cycle:
DOOR LOCK | RINSING |
PREWASHING | DRAINING |
WASHING | SPINNING |
ADDING STEAM | CYCLE COMPLETE |
Snap
Hinge
3
2
1
13