JVC KD-R311 manual Basic operations, Setting the clock, Select Clock Select Clock SET, For KD-R414

KD-R414/KD-R314

CD RECEIVER : INSTRUCTIONS/INSTALLATION

Thank you for purchasing a JVC product.

Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit.

IMPORTANT FOR LASER PRODUCTS

1.CLASS 1 LASER PRODUCT

2.CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel.

3.CAUTION: Visible and/or invisible class 1M laser radiation when open. Do not view directly with optical instruments.

4.REPRODUCTION OF LABEL: CAUTION LABEL, PLACED OUTSIDE THE UNIT.

	Warning:
[European Union only]	If you need to operate the unit while driving, be sure
	to look around carefully or you may be involved in a
	traffic accident.

1009DTSMDTJEIN
EN	GET0659-001A
© 2009 Victor Company of Japan, Limited	[UI]

Canceling the display demonstration

1	Turn on the power.	4	Select <DEMO OFF>.
2	[Hold]	5
3	(Initial setting)
		6	Finish the procedure.

Basic operations

Ejects the disc Control dial Loading slot

Detaches the panel

Remote sensor

• DO NOT expose to bright sunlight.

When you press or hold the following button(s)...

Display window

Auxiliary input jack

For KD-R414

USB (Universal Serial Bus) input jack

Setting the clock

1Turn on the power.

2

[Hold]

(Initial setting)

3Select <CLOCK>.

4Select <CLOCK SET>.

Preparations

How to attach/detach the control panel

How to reset your unit

5Adjust the hour.

6Adjust the minute.

7Finish the procedure.

Preparing the remote controller (RM-RK50)

When you use the remote controller for the first time, pull out the insulation sheet.

Insulation sheet

Main unit	Remote	General operation
	controller

Turns on.

•When the power is on, pressing /I/ATT on the remote controller also mutes the sound or pauses. Press /I/ATT again to cancel muting or resume playback.

Turns off if pressed and held.

Selects the available sources (if the power is turned on).

• If the source is ready, playback also starts.

Adjusts the volume level.

—Selects items.

• Mutes the sound while listening to a source. If the source is “CD“ or “USB (for

—	KD-R414),“ playback pauses. Press the control dial again to cancel muting or
	resume playback.
	• Confirms selection.
	Selects the sound mode.
	• Enters tone level adjustment directly (see page 2) if pressed and held
	EQ BASS-TREon the main unit.
—	Enters playback mode menu directly (see page 2).
—	Returns to the previous menu.
—	Power off : Checks the current clock time.
	Power on : Changes the display information.

Reset the unit after installation is completed.

• Your preset adjustments will also be erased.

How to forcibly eject a disc

[Hold]

•You can forcibly eject the loaded disc even if the disc is locked. To lock/unlock the disc, see page 2.

•Be careful not to drop the disc when it ejects.

•If this does not work, reset your unit.

For safety...

•Do not raise the volume level too much, as this will block outside sounds, making driving dangerous.

•Stop the car before performing any complicated operations.

Temperature inside the car...

If the effectiveness of the remote controller decreases, replace the battery.

Replacing the lithium coin battery

CR2025

Caution:

•Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

•Battery shall not be exposed to excessive heat such as sunshine, fire, or the like.

Warning (about battery handling)

To prevent accidents and damage:

• Do not install any battery other than CR2025 or its

equivalent.

• Store out of reach of children.

• Do not recharge, short, or dismantle.

Maintenance

How to clean the connectors

Wipe the connectors with a cotton swab or cloth moistened with alcohol.

Connectors

Moisture condensation

Moisture may condense on the lens inside the unit. Eject the disc and leave the unit turned on for a few hours until the moisture has evaporated.

To keep discs clean

Wipe in a straight line from center of disc to edge. Do not use liquid cleaners, thinners, or benzene.

To play new discs

Remove any rough areas from the inner and outer edges of the disc.

Do not use the following discs:

•Single CD (8 cm disc)

•Warped disc

•Disc with sticker and sticker residue

•Disc with stick-on label

•Unusual shape disc

•C-thru Disc (semi-transparent disc)

•Disc with transparent or semi-transparent parts on its recording area

If you have parked the car for a long time in hot or cold weather, wait until the temperature in the car becomes normal before operating the unit.

• Do not dispose of in fire.

• Do not carry around with other metallic materials.

• Wrap the battery with tape and insulate when

throwing away or saving it.

Microsoft and Windows Media are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.

1