Fisher & Paykel GWLO8 manual Water Levels, Auto Water Level, Manual Water Level Selection

Page 13

WATER LEVELS

AUTO WATER LEVEL

Your Smart Drive can automatically select the appropriate water level for the load.

1.Place your clothes in the machine.

2.Select wash cycle (select AUTO if not automatically selected).

3.Press START / PAUSE.

During fill the machine will pause occasionally

to sense the water level. The machine will check if the water level is correct by using a series of two different agitate strokes. A slow stroke to sense the load and an agitate stroke to mix the load. (This may take over a minute). If it detects that the water level is not enough it will fill with more water and re-check the level.

•When washing an unusual load eg large bulky garments, pillows, we recommend you manually select the water level.

•Manually select the water level if there is already water in the machine.

Note: If you feel the machine does not fill to the correct level, you can adjust the level the machine selects. Refer to the Option Adjustment instructions on pages 23 and 27.

MANUAL WATER LEVEL SELECTION

The agitator has five levels marked on its stem that can be used to help you select the correct water level. Select the correct water level by using the mark nearest to the top of the clothes.

•The levels marked on the agitator do not correspond exactly to the level of water. They indicate the level of dry clothes suitable for the water level.

•Your Smart Drive may occasionally add water during agitation. This is to maintain the water level due to the release of air trapped in the garments.

High

Med/high

Medium

Med/low

Low

ACTUAL LEVEL OF WATER

11

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Use Care Page Contents Hydrogen GAS can be Explosive Under These Circumstances Water Heater SafetyPage Do not tamper with the controls Important Safety InstructionsOperating Instructions Loading Using Your Smart Drive Power and WaterDetergent BleachWash Cycle Fabric SoftenerWash Options StartWash Cycles Wash Cycles and OptionsDuty To Alter the Wash Options Changing the Wash OptionsWarm HOT Warm Cold Advancing the Wash Cycle Clothes Care SafeguardsTo Shorten the Wash Time Stopping the MachineAuto Water Level Water LevelsManual Water Level Selection Actual Level of WaterTo USE Water Saver Water SaverTo USE Delay Start Delay StartTime Saver To USE Time SaverSpin Hold SoakTo USE Soak To USE Spin HoldProgramming Your Favorite Cycle Favorite CycleTo USE Favorite Cycle To Customize the Wash Cycles Customizing the Wash CyclesWool Cycle is for washing Washing WoollensMachine Washable Woollens Sorting Before YOU WashWashing Bulky Items LoadingBefore Washing Maximum Wash LoadScrud DetergentChoosing the Right Detergent HOW Much DETERGENT?Fabric Softener Cleaning the DispenserBleach HOW the Fabric Softener is DispensedDiaper Sanitizers HOW to Remove StainsTo Enter Option Adjustment Mode Option Adjustment ModeChanging PRE-SET Options Press Start / Pause and hold down. Press Power Rinse Options Volume of Water Used in the Water Saver OptionRinse Options END of Cycle Beeps OUT of Balance Recovery RoutineAuto Water Fill Level Machine Information Care and CleaningProducts That Might Damage Your Smart Drive Smart Drive Sounds and BeepsDimensions Model SpecificationsL08 Water Consumption Rinse OptionsSaving Water Problem SolvingRecycling the Wash Water Recycling the Water from Deep RinseReturn Hose to Drain Manual Suds Save with Siphon BackProblems Wash ProblemsAuthorized Service Agent Operating ProblemsSymptoms Machine is Giving a Short Burst of BEEPS* If Your Smart Drive Beeps for HelpIf the Machine Beeps ContinuouslyToll Free 888 9FNP USA 888 936 Washer WarrantyPage Proof of Purchase ServiceModel Number Serial No Purchaser Dealer Address
Top Page Image Contents