MANUAL SUDS SAVE WITH SIPHON BACK
If you have a large tub near your washing machine and a separate drain outlet you can set up another method of reusing the water.
(The tub should hold a minimum of 27 gallons (100 litres) or have an overflow.)
1.Select SOAK on the first wash cycle.
2.At the end of the wash phase place the drain hose in the tub.
3.Cancel SOAK (press ADVANCE button). The suds water will be pumped into the tub. Do not leave your machine until pump out is completed.
4.ONCE YOUR TUB IS FILLED RETURN THE DRAIN HOSE TO THE DRAIN. THIS MUST BE DONE BEFORE THE MACHINE STARTS SPINNING.
5.Allow the machine to complete the rest of the cycle. Remove the first wash load and place the second load in the machine.
6.To siphon back the suds place the end of the drain hose in the tub, ensure that the end is near the bottom of the tub.
7.Advance to SPIN and allow the machine to pump for a few seconds to clear air from the drain hose, then press POWER to turn the machine off.
8.The suds water will siphon back into the machine. It will take several minutes to siphon back the water.
9.RETURN HOSE TO DRAIN.
10.Select second wash cycle.
The above method can also be used to recycle the water from a deep rinse. Select SPIN HOLD in place of SOAK.
Note: For any of the above methods, manually select the water level for the second wash load. Auto water level may fill to a level too high for the clothes load if there is already water in the washing machine.
Note: You will only be able to siphon back into the machine until the water level is equal to that in the tub.
32