Kenmore 134966700 dimensions Location of Your Washer, Do not Install Your Washer, Unpacking

Page 4

LOCATION OF YOUR WASHER

DO NOT INSTALL YOUR WASHER:

I.In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60 ° F (15.6 ° C) for proper washer (detergent breakdown) operation.

2.In an area where it will come in contact with curtains or drapes.

3.In an area (garage or garage-type building) where gasoline of other flammables are kept or stored (including automobiles).

4.On carpet. Floor MUST be solid with a maximum slope of 1/2 in. per foot (1.27 cm per 30.5 cm). To ensure vibration or movement does not occur, reinforcement of the floor may be necessary.

IMPORTANT

MINIMUM INSTALLATION CLEARANCES

When installed in alcove or closet:

Sides, Rear = 0 in. (0 cm)

Top = 0 in. (0 cm)

When installed in closet: Front = I in. (2.54 cm)

Closet door ventilation required: 2 Iouvered openings each 60 in2(387 cm2), 3 in. (7.6 cm) from top and bottom of door.

UNPACKING

1.Cut the shipping carton along the dotted line along the bottom. Remove the carton.

2.Using a rug, blanket or piece of cardboard to protect the floor, lay the washer on it'sback.

3.Remove and savethe styrofoam base and shipping plug.

Shipping

BasePlug

Image 4
Contents Full Size Tumble Action Washers PRE-INSTALLAT!ON Requirements Electrical RequirementsGrounding Requirements Water Supply RequirementsROUGH-INDIMENSIONS InchescmDo not Install Your Washer Minimum Installation ClearancesLocation of Your Washer UnpackingMetal P clamp Hose clipsZeve/ing the Washer Washer ConnectionsReplacement Parts Cable Tie