4.Carefully return the washer to an upright position.
Carefully move the washer to within 4 feet (122cm) of the final location.
. Remove the following from the back panel of the washer:
4 shipping bolts,
4spacers,
1metal "P" clamp,
2hose clips.
. Remove the 4 plugs from the literature pack located in the drum and install them in the holes vacated by the packaging spacers.
NOTE: If the washer is to be transported at a later date, the shipping support hardware must be reinstalled
to prevent shipping damage.
Remove:
metal "P" clamp
4shippingJbbolts,
4spacers.
hose clips
INSTALLATION
Zeve/ing the Washer
Excessive noise and vibration can be prevented by properly leveling the washen
. For free standina installation and with the washer in it's final position, place a level on top of the washer. Adjust the leveling legs so the washer is level
Pressdown on alternate corners and sides and feel for the slightest movement. Adjust the appropriate leg so the washer is SOLID on the floor on ALL four legs. Keep the
leveling leg extension at a minimum for best performance of the washer.
Washer Connections
1.Run some water from the hot and cold faucets to flush the water lines and
remove particles that might clog up the water valve screens.
Remove the inlet hoses and rubber washers from the plastic bag located in the drum of the washer and install the rubber washers in each end of the inlet hoses.
3.Carefully connect the inlet hose marked "HOT" to the outside "H" outlet of the water valve. Tighten by hand,
then tighten another 2/3 turn with pliers. Carefully connect the other inlet hose to the inside "C" outlet of the water
valve. Tighten by hand, then tighten another 2/3 turn with
pliers. Do not crossthread or over-tighten these
connections.
4.Connect the inlet hose ends to the HOT and COLD water faucets tightly by hand, then tighten another 2/3 turn with pliers. Turn the water on and check for leaks.
NOTE: Use only new hoses.
2.For pedestal installations, See additional installation instructions included with the pedestal.