HE-8000 89

15. ERROR CODE TABLE

15. ERROR CODE TABLE
If a malfunction should occur with the sewing machine, a buzzer will sound and an error code will appear in
the display window.
Follow the remedy procedure to eliminate the cause of the problem.
For errors which do not require the power to be turned off (i.e. errors which can be reset), two short beeps
will sound. For error E-02, three short beeps will sound.
For errors which require the power to be turned off (i.e. errors which cannot be reset), a single long beep will
sound.
Code Cause Remedy
E-00 EMERGENCY STOP switch was pressed. To restart sewing: Press the parameter down key and
then depress the treadle to step 2.
To cancel sewing: Press the RESET key.
E-01 Upper thread breakage To restart sewing: Press the parameter down key and
then depress the treadle to step 2.
To cancel sewing: Press the RESET key.
E-02 Needle up sensor is OFF. Turn the machine pulley by hand to raise the needle.
E-05 Zigzag positioning is not carried out. Turn off the power.
E-06 Feed positioning is not carried out. Turn off the power.
E-07 Work clamp positioning is not carried out. Turn off the power.
E-08 Cutter home position sensor is off. Turn off the power.
E-20 Feed and work clamp motor overcurrent Turn off the power.
E-21 Zigzag motor overcurrent Turn off the power.
E-30 Treadle is depressed to step 2. Return the treadle to the neutral position.
E-31 Treadle is depressed to step 1. Return the treadle to the neutral position.
E-32 Treadle is depressed backward. Return the treadle to the neutral position.
E-40 Control board heat sink is overheating. Turn off the power.
E-41 Inside air circulation fan problem Turn off the power.
E-42 Exhaust fan problem Turn off the power.
E-44 2-step power supply circuit board +55V relay error Turn off the power.
E-50 Pattern shape does not match pattern shape specifica-
tions.
Pattern shape for data created using the BAS-PC/300
does not match the pattern shape specifications.
Turn off the power.
E-51 X pitch error Turn off the power.
E-52 Y pitch error Turn off the power.
E-54 Overall cycle program stitch no. error Exceeds 3,000 stitches.
Clear the cycle program and reset automatically.
E-55 Stitch no. error Exceeds 700 stitches. Turn off the power.
E-59 Sewing data error Turn off the power.
Re-initialize the programs.
DAN
G
ER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from
the wall outlet before opening the face plate of the control box. Touching areas where high voltages
are present can result in severe injury.