(2)
(4)
(1)
(5)
(3)
2084Q
4. INSTALLATION
Adjusting the belt retainer
1.Loosen the screw (1).
2.Align the boss of the belt retainer (2) with the mark (3).
3.Tighten the screw (1).
Adjusting the finger protector
1.Loosen the screw (4).
2.Align the center of the screw (4) with the mark (5).
3.After adjusting, tighten the screw (4).
4-13. Installing the belt cover plate
NOTE:
If the machine head is positioned horizontally, there is no need to install the belt cover plate.
(1)
(1)
(3)
(2)
(2)
3 mm or more
2085Q | 2086Q |
1.Set the belt cover plate (1) so that there is a gap of 3 mm or more in the longer motor direction. The belt cover plate (1) should not project out from the edge of the work table.
2.Install the belt cover (1) with the wood screws (3) so that it does not touch the motor belt cover (2).
21 |
