HE-8000

90

15. ERROR CODE TABLE
Code Cause Remedy
E-62 Needle up error during operation Turn off the power.
E-63 Needle down error during operation Turn off the power.
E-64 Timing signal error during operation Turn off the power.
E-70 Machine motor running error Turn off the power.
E-74 EEPROM error Turn off the power.
E-80 Communication ready error Turn off the power.
E-81 Communication error Turn off the power.
E-90 Machine motor overload Excessive load during sewing. Turn off the power.
E-92 Machine motor operation error Turn off the power.
E-93 Blown solenoid fuse Turn off the power. Replace the fuse.
E-94 Machine motor IC error Turn off the power.
E-95 Power supply voltage error (high) Power supply voltage is too high. Turn off the power.
E-96 Power supply voltage error (low) Power supply voltage is too low. Turn off the power.
ArEA Sewing data values exceed the needle plate size or
work clamp size which have been set using the panel
DIP switches.
Three resetting methods are available depending on
the application.
A. By selecting a different program number (If you would
like to keep the program which exceeds the area.)
Press the SELECT key.
Select a different program number.
Press the ENTER key.
If the data for the selected program number does not
exceed the sewing area, the error will be cleared.
B. By initializing the program
While pressing the ENTER key, press the RESET key.
* All parameters (00 to 69) for the program will
then be initialized and the machine will switch to
program mode.
C. By initializing all programs
Refer to "12. PROGRAM INITIALIZATION".
C-Er When using the multi-working knife, the knife operation
distance cannot be reduced.
Three resetting methods are available depending on the
application.
A. Replace the knife with a longer k nife.
Press the SELECT key to change to automatic mode.
Press the SELECT key to change to pr ogram mode.
Enter the length of the new knife as the setting for
parameter 02 (Length of knife).
Press the SELECT key to change to automatic mode.
* If "C-Er" is displ ayed again, replace with an even
longer knife.
B. By initializing the program
Initialize only the programs which cause "C-Er" to be
displayed.
While pressing the ENTER key, press the RESET key.
* All parameters (00 to 69) for the program will be
initialized.
C. Change the zigzag pitch and zigzag stitch length
(multi-working knife).
1. Press the SELECT key to change to automatic mode.
Press the SELECT key to change to pr ogram mode.
2. Reduce the setting value for parameter 04 (Zigzag
pitch). Increase the setting for parameter 03 (Zigzag
stitch [multi-working knife]).
3. Press the SELECT key to change to automatic mode.
* If "C-Er" is still dis played, repeat steps 1. to 3.