![](/images/new-backgrounds/1052565/52565147x1.webp)
8. SEWING
* DIP switch A-1 = ON
Sewing completes with
no thread breakage
(work clamp still lowered)
Thread breakage occurs just before sewing is complete, but sewing completes before it is detected
(work clamp still lowered)
Thread the thread.
Resuming sewing
Press the parameter down key (16) to move to the point to resume sewing.
Re-sewing
While pressing the parameter down key (16) press the RESET key (3). (Machine will return to sewing start position.)
Select a different program to be retrieved.
*For example, select a program which includes underlays sewn together, and then press the ENTER key (17).
Finishing sewing
Press the RESET key (3). (Thread will be trimmed and work clamp will be raised.)
Select the cutter operation.
(If cutter operation is not needed, press the CUTTER ON key (5) to turn off the cutter.)
Depress the treadle. (Resuming sewing)
Depress the treadle.
Depress the treadle backward (Thread will be trimmed and work clamp will be raised.)
Depress the treadle. (Machine will start and next sewing will be carried out.)
* If using a different program, press the CUTTER ON key (5) to turn the cutter back on if it has been turned off.
8-1-4. When resuming sewing in test feed mode or manual mode
1.Use the SELECT key (13) to switch to either test feed mode or manual mode.
2.Move to the point to resume sewing using the operations that apply to whichever mode being used.
*Refer to
NOTE:
If using manual feed mode, raise the needle bar to its highest position before proceeding to step 3. below.
If the needle bar is not at its highest position when step 3. below is carried out, error
3.While pressing the ENTER key (17), press the SELECT key (13).
*The mode will change to automatic mode and
NOTE:
When step 3. is carried out, the mode cannot be returned to test feed mode or manual mode.
4.Press the parameter up key (15) or the parameter down key (16).
*The
5.Depress the treadle.
*Sewing will start from the current position.
8-1-5. Lower thread counter
•When panel DIP switch
1.When the lower thread counter reaches 0, replace the lower thread.
•The sewing machine will not start at this time, even if the treadle is pressed.
2.Press the ENTER key (17).
•The lower thread counter setting value will appear in the parameter display LED (14) and normal sewing can then be carried out.
*To change the lower thread counter setting value, refer to
67 |