Motorola HE-8000 I Program setting method, Program initialization condition, Parameter table

5. OPERATION

5-4. Program setting method

5-4-1. Program initialization condition

The parameters and memory switches for program numbers 1 to 90 are all set to their default values.

5-4-2. Parameter table

•The parameter values can be stored independently for each program.

•The allowable setting range for some parameters may vary from the range specified, depending on the settings of other parameters.

•The number of stitches which can be sewn may vary depending on settings for parameters such as zigzag width and feed length.

•The zigzag width ratio cannot be set when the rear tack pattern is set to an eyelet pattern.

•If all underlays have been set, the order of sewing is underlays sewn together, then saw-shape underlays

and then rectangle underlays.

*The cutter operating distance may become smaller depending on the settings for parameter No. 2 (Length of knife) and parameter No. 3 (zigzag stitch length [multi-working knife]), so in such cases the speed will be reduced automatically.

No.			Setting items			Setting range	Unit	Default
00 Sewing speed (zigzag part)						1,000 – 4,000 rpm	100	3,600
01	Buttonhole/Straight bar tack					0: Buttonhole (free)		1
	0:	1:	2:	3:	4:	1: Buttonhole (rectangle)
						2: Buttonhole (radial)
						3: Buttonhole (round)
						4: Bar tack
					1437Q
02	Length of knife					4.0 - 32.0 mm	0.1	13.0
						However, when panel DIP		(6.0)
						switches B-3, B-4 or B-5
						are at OFF, OFF and ON
						respectively when initializa-
						tion is carried out, the initial
						value will be set to 6.0.
					1438Q
03 Zigzag stitch length (multi-working knife)						OFF: Single working knife	0.1	OFF
						4.0 - 69.0 mm
						However, the setting range
						will be limited by the work
						clamp size setting value
						which has been set by the
						B panel DIP switches.
					1439Q
04	Zigzag pitch					0.10 - 2.00 mm	0.025	0.350

1440Q

HE-8000 33