HE-8000
8. SEWING
64
8-1-1. If the emergency stop switch is pressed during sewing
The sewing machine will stop and "E-00" will appear in the parameter display LED (14).
Turn the knob of the emergency stop switch to the right to release it.
1. To finish sewing in this condition Next sewing
1) Press the RESET key (3).
(The feed mechanism will return to the sewing start position and the work clamp will rise.)
2) Sewing will start again when the treadle is depressed.
2. To start sewing again from slightly before or after the emergency stop point
Resuming sewing
1) Press the parameter UP key (15) to move the zigzag and feed mechanisms to the next sewing
position. Press the parameter DOWN key (16) to move the zigzag and feed mechanisms to the
previous sewing position. (The "E-00" display will be cleared at this time.)
2) Move to the position to continue sewing from, and then depress the treadle. The rest of the sewing will
be carried out.
3. To sew from the sewing start point without raising the work clamp (without shifting the material)
Re-sewing
1) W hile pressing the parameter DOWN key (16), press the RESET key (3).
(The feed mechanism will return to the sewing start position, but the work clamp will not rise.)
2) Depress the treadle to start sewing.
* If panel DIP switch A-3 is set to ON, an emergency stop will occur when the treadle is depressed, in
the same way as when the emergency stop switch is pressed.
NOTE:
Turn the power off before changing the DIP switch settings. If the settings are changed while the power is
still on, they will not take effect.
NOTE:
Forcing emergency stops using the treadle only works while the sewing machine is running. If the sewing
machine is stopped, the work clamp will be raised.
(14)
(15)
(16)
(3)
2155Q