Motorola LH4-B800E, HE-8000 I instruction manual Bar tacking stitches being cut by the knife

5. OPERATION

(14)

(15)

(16)

(17)2115Q

4.Use the parameter keys (15) and (16) to change the setting for the selected parameter. (Example: Buttonhole (round) setting value - 3.)

(When you press the ENTER key (17), the parameter setting will be changed and the parameter display LED (14) will stop flashing. The setting will not be changed if the ENTER key (17) is not pressed.)

5. Repeat steps 3 and 4 to change other parameter settings.

Checking the length of knife

			Use the program No. keys (7) and (8) to select
			parameter No. 02.
			(Parameter No. 02 is used to set the length of the
			knife.)
			Check that the length of the knife which is has
			been installed is the same as the length setting
		(14)	which appears in the parameter display LED (14).
			If the values are different, use the parameter keys
(7)		(15)	(15) and (16) to change the parameter setting
(8)			value so that it is the same as the length of the
		(16)	knife, and then press the ENTER key (17).
			(The length of the knife has now been set.)
			NOTE:
		(17)	Be sure to change the knife length setting if the
			knife is replaced with a knife of a different
			length.
			The stitch length will be automatically determin-
			ed by the value for the length of the knife which
			has been set. Therefore, if the knife length is
			not set correctly, problems may occur, such as
	2116Q		the bar tacking stitches being cut by the knife.
			6. Press the SELECT key (13) to change the mode
			to automatic mode.
			* A round buttonhole sewing pattern has now
			been set for program No. 03.
			* The setting details can be saved in the pro-
			gram notes of the program memos for easy
			checking.

(13)2117Q

44 HE-8000