Kenmore 3950145 Connect Inlet Hoses to Washer, For standpipe or laundry tub drain systems

For standpipe or laundry tub drain systems:

STEP 2. Open yellow, single-wire clamp

with pliers and slide over hooked end of drain hose to secure the rubber and

corrugated sections together.

HookedEnd

STEP 3. Put hooked end of drain hose

into laundry tub or standpipe. Check for proper length of drain hose. Rotate hook to eliminate kinks.

To prevent drain water from going back into the washer:

•Do not straighten hooked end of drain hose and force excess drain hose into

standpipe.

•Do not lay excess drain hose in bottom of laundry tub.

D. CONNECT INLET HOSES TO WASHER

Proper connection of your inlet hoses will allow hot and cold water to enter

your washer properly. It also helps prevent water damage due to leaks.

Slip and Fall Hazard

Use new water inlet hoses.

Failure to do so can result in head injury or broken bones.

NOTE: Replace inlet hoses after five years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.

STEP 1. Insert one new, flat washer

(from the parts bag) into each end of the inlet hoses, Check that washers

are firmly seated in couplings.

0

COUPLINGWASHER

15