Kenmore 110.29882891 Cleaning Your Washer, Winter Storage or Moving Care, Water Inlet Hoses

Page 32

CLEANING YOUR WASHER

Proper care of your washer can extend its life. This section explains how to care for your washer properly and safely.

Exterior

Wipe up detergent, bleach, and other spills with a soft, damp cloth or sponge as they occur. Occasionally wipe the outside of the washer to keep it looking like new.

Do not put sharp or metal objects in your washer. They can damage the finish. Check all pockets for pins, clips, money, bolts, nuts, etc. Do not lay these objects on your washer after emptying pockets.

Interior

Clean interior with 1 cup of chlorine bleach mixed with 2 cups of detergent. Run washer through a complete cycle using hot water. Repeat process if necessary.

NOTE: Remove hard water deposits using only cleaners labeled as washer safe.

Replace inlet hoses after five years of use to reduce the risk of hose

failure. Periodically inspect and

_ WATER INLET HOSES

replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When

replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.

WINTER STORAGE OR

MOVING CARE

Install and store your washer where

it will not freeze. Because some water may stay in the hoses, freezing can damage your washer. If storing or

moving your washer during freezing weather winterize it.

To winterize washer:

1.Shut off both water faucets.

2.Disconnect and drain water inlet hoses.

3.Put 1 quart of R.V.-type antifreeze in the basket.

4.Run washer on a SPIN setting for about 30 seconds to mix the anti-

freeze and water. Some of the mixture will pump out while the washer spins.

5.Unplug the power supply cord.

To use washer again:

1.Flush water pipes and hoses.

2.Reconnect water inlet hoses,

3.Turn on both water faucets.

4.Reconnect power supply cord.

5.Run the washer through a complete cycle with 1 cup of detergent to clean out antifreeze.

NON-USE OR VACATION CARE

Operate your washer only when you

are at home. If you will be on vacation or not using your washer for an extended period of time, you should:

Unplug the power supply cord or turn off electrical power to the washer.

Turn off the water supply to the washer. This helps avoid accidental flooding (due to a water pressure surge) while you are away.

32

Image 32
Contents OwnersManual Installation Instructions Your washer may look differentLaundry Tips Caring For Your Washer Before Using Your NEW WasherSafety Instructions Full 1-YEAR Warranty On Mechanical Electrical Parts Limited 5-YEAR Warranty on Gearcase PartsLimited 10-YEAR Warranty on Plastic TUB Sears, Roebuck and Co., Dept WA, Hoffman Estates, ILYour Safety is Importantto US Installation Overview For a complete list of tools and parts Needed, see pagesSelect Location Standpipe Drain System p Floor Drain System pConnect Drain Hose pgs Tools Needed Parts Needed Remove Shipping Strap pTools Needed Connect Inlet Hoses to Washer pgs Tools Needed Parts Needed Flashlight optional Wood block Depending on installation Secure Drain Hose pElectrical Requirements Grounding Instructions mRecessed Area Closet Installation Instructions This washer may be installed in a recessed area or closetSelect Location For Your Washer If other appliLaundry TUB Drain System Alternate Locations Standpipe and Floor Drain Systems Pin Remove Shipping StrapElectrical plug Shipping strap Connectdrainhose Drain hose with tap water. do not USE ANY Other LubricantIf you have You will need to buyConnect Inlet Hoses to Washer For standpipe or laundry tub drain systemsHookedEnd Put hooked end of drain hose Are firmly seated in couplingsConnectinlethoses Towater Faucets If you Have You Will Need BuySecure Drain Hose To install front legs LevelwasherLocation Prop front of washer up aboutReview Installation ElectricalTurned on Final StepsTo the right to desired setting see Starting WasherSTOPPING/RESTARTING Washer Load see Push the Cycle SelectorSET Water Level Control Washers with a variable Water Level ControlWater Level Washers with a 4- or 5-position Water Level ControlSET Water Temperature Control Selecting Water TemperaturesHOT WarmAutomatic Temperature Control ATC Speeds DescriptionsSelector Timer Control Setting Your Rinse Options Control Rinse and SpinONE2ND Rinserinse Spin onlySELF-CLEANING Lint Filter Double ROLL-OVER DUAL-ACTION AgitatorQuiet PAK TM Understanding Normal Washer SoundsUsing the Liquid Chlorine Bleach Dispenser Liquid chlorineUsing the Liquid Fabric Softener Dispenser Liquid fabric softener Spenser Blue lock ring Soak Understanding What Happens in Each Cycle Ultra Clean Permanent Press Prewash Preparing Clothes For Washing SortingLoading Loading SuggestionsSuper Capacity Plus Washers EXTRA-LARGE Capacity Plus WashersCleaning Your Washer Winter Storage or Moving CareNON-USE or Vacation Care Water Inlet HosesProblem Possible Cause Solution Washer Leaks WashersWont Drain Wont Spin CloggedWont Spin Wet Loads Cords ContContinues To FillProblemPossible Cause StopsAgitator Not WorkingDo not wrap items around agitator when loading washer Stains on Improper use of fabricKenmore Washers Call8OO-4-REPAIR Importante Acuerdo DE Mantenimiento Sears Cuidado DEL Lavarropas Localizacion Reparacion DE AverasINSTRUCClONES Sears Roebuck and Co., Dept WA, Hoffman Estates, IL Garanta Integral DE 1 Aiio EN LAS Piezas MEC.&.NICAS YSobre LAS Piezas DE LA Caja DEL Engranaje Suseguridadnosimportamuchisimo Guarde Estas InstruccionesSistema de desagJe por pila para lavar ropa pdg Sistema de desagJe por el suelo pdgConecte LA Manguera DE Desague pdgs De agua Conecte LAS Mangueras DE Entrada DE Agua AL LavarropasHerramientas Necesarias Piezas necesarias Arandela Niveladora Pdg=,,====,=== Demanda ElectricaInstrucciones Para LA Puesta a Tierra Escoja EL Lugar Donde Desea Instalar EL Lavarropas 1110,161r Cm r Icml cm99,06 cm Pulg Sistema DE Desagoe POR Tina DE LavadoPage Quite LA Banda DE Sujecion Para Transporte AlfilerConectelamanguera DE Desague Gire EmpujeMm Manguerade Pulg De mangueras No. de piezaManguerade desagiie Conecte LAS Mangueras DE Llenado AllavarropasConecte LAS Mangueras DE Entrada a LOS Grifos DE Agua Ajuste LA Manguera DE Desagoe Banda de sujeciGnNivele EL Lavarropas Revise LA Instalacin Pasos FinalesPuesta EN Marcha DEL Lavarropas Como Detener Y Volver a Poner EN Marcha EL LavarropasPosicionamientodel Control DE Nivel DEL Agua Caliente Posicionamiento DEL Control DE Temperatura DEL AguaSeleccion DE Lastemperaturas DEL Agua Control Automatico DE LA Temperatura ATC Delicado DelicateRegular Regular Lavado Pesado Heavy DutyUltralimpio Ultra Clean 0 Normal Normal Inarrugables Permanent PressPress Prelavado PrewashULTRACLEAN1 ONE2ND Rinserinse Enjuague Y CentrifugadoCMO Fijar EL Control DE Opciones DE Enjuague Centrifugado SolamenteAgitador DE DUAL-ACTION Doble Accion Comprensin DE LOS Sonidos Normales DEL LavarropasUSO DEL Recipientedistribuidor Delejeaclorada Ljquida Lejia clorada liquidaUSO DEL REClPIENTE Distribuidor DEL Suavizador DE TejidosComprenda LO QUE Sucede EN Cada ClCLOIII 2DO EnjuaguePreparacin DE LA Ropa Para Lavar SeparacionCarga Sugerencias Para Preparar LA CargaLavarropasde Capacidadsuperiorplus Lavarropasde GranLimpieza DEL Lavarropas Mangueras DE Entrada DE AguaAlmacenaje Invernal O Cuidado Durante LA Mudanza Durante LAS VacacionesPage Page Probable De 16C 60FSe est& usando enjuagues tibios El agua de lavado no se calienta IoSuficiente para relajar las arrugas Las mangueras estn instaladasLavarropas Kenmore Para obtener mas informacibn Ilame al8OO-366-PART