H ow to use washer
WASH/RINSE TEMPERATURE. |
| SPIN |
|
|
|
•Press TEMP. to cycle through
the temperature choices. | WARM/WARM | |
• Select a water temperature | WARM/COLD | |
based on the type of load you | COLD/COLD | |
TAP COLD/COLD | ||
are washing. Use the warmest | ||
| ||
water safe for fabrics. Follow | TEMP. | |
garment label instructions. | ||
| ||
• Warm rinses leave the loads |
| |
dryer than cold rinses. Warm |
|
1400
1000
800
400
NO SPIN
RINSE HOLD
SPIN
•By pressing the SPIN button, the spin rpm can be chosen.
-RINSE HOLD
-NO SPIN
-400
-800
-1000 -1400
rinses increase wrinkling. In cold |
climates, a warm rinse makes the load mere |
comfortable to handle. Cold rinses save energy.
•Warm rinses are regulated at approximately 75˚ F (24˚ C). This is a cooler warm rinse than you are used to, but it saves energy and gives proper rinsing. The load is a comfortable temperature remove from the washer.
1. Wash/Rinse Temperature
•Water temperature can be selected as below according to the program.
-SANITARY HOT/COLD
-COTTON
WARM/COLD ➔ WARM/WARM➔HOT/COLD ➔
TAP COLD/COLD ➔ COLD/COLD
-PERM. PRESS
WARM/COLD➔WARM/WAR➔TAP COLD/COLD➔COLD/COLD
-WOOL/SILK & RINSE+SPIN COLD/COLD ➔ WARM/COLD ➔
WARM/WARM➔TAP COLD/COLD
Selected temperature’s lamp turns on.
For the more detailed information, please refer to the page12.
Temperature Guide
Wash Water Temperature | Suggested Fabrics |
Hot | Whites and pastels |
111˚ F (44˚ C) or above | Heavy and greasy soils |
|
|
Warm | Bright colors |
Moderate to light soils | |
|
|
Cold | Colors that bleed or fade |
Light soils | |
|
|
In wash water temperatures colder than 70˚ F (21˚ C),
detergents do not dissolve well. Soils may be difficult to remove.
1.Spin selection
•Spin rpm is available according to the program as follows.
[Wash Programs]
-SANITARY & COTTON & RINSE+SPIN
800➔1000➔1400➔Rinse Hold➔No Spin➔400
-PERM. PRESS
800➔1000➔Rinse Hold➔No Spin➔400
-WOOL/SILK
400➔800➔1000➔Rinse Hold➔No Spin
[Wash/Dry Programs]
-SANITARY & COTTON & RINSE+SPIN 1400➔800➔1000
-PERM. PRESS 1000➔ 800
2.No spin
•If NO SPIN is selected, the washer stops after draining water.
The required lamp will light up for identification.
3.Rinse Hold
•Is selected by pressing the SPIN button repeatedly this function leaves clothes in the washer; suspended in the water after a rinse without entering into spin.
•To proceed through to a drain or spin, once the rinse hold function is completed using to program dial scroll to the required program. (Spin or Pump)
The required lamp will light up for identification.
15