M aintenance
❋Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock to avoid electrical shock hazards.
❋When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside.
The water inlet filter
-" 
" error message will blink on the control panel when water does not enter the detergent drawer.
-If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.
It is therefore a good idea to clean it from time to time.
1.Turn off the water tap.
3.Clean the filter using a hard bristle brush.
2. Unscrew the water inlet hose.
4. Tighten up the inlet hose.
The drain pump filter
❋The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
!CAUTION First drain using the drain hose and then open the pump filter to remove whatever any threads or objects.
Be careful when draining if the water is hot.
❋Allow the water to cool down before cleaning the drain pump, carrying out emergency emptying or opening the door in an emergency.
1.Open the lower cover
cap (
) by using a coin. Turn the drain
plug ( 
) to pull out the hose.
100
2.Unplug the drain plug (
), allowing the water to flow out. At
this time use a vessel to prevent water flowing on to the floor. When water does not flow any more, turn the pump filter (
) open to the left.
3.Remove out any foreign material
from the pump filter (
). After cleaning, turn the pump filter (
) clockwise and insert the drain
plug (
)to the original place. close the lower cover cap.
1
3
32
2
21