T roubleshooting guide
Symptom | Possible Cause | Solution |
| • Water supply is not adequate in area | Check another tap in the house. |
| • Water supply taps are not completely | Fully open tap. |
| open. | Straighten hose(s). |
| • Water inlet hose(s) are kinked. | |
| • The filter of the inlet hose(s) are | Check the filter of the inlet hose(s). |
| clogged. |
|
| • Drain hose is kinked or clogged. | Clean and straighten the drain hose. |
| • The drain filter is clogged. | Clean the drain filter. |
| • Load is too small. | Add 1 or 2 similar items to help |
| • Load is out of balance. | balance the load. |
| • The appliance has an unbalance | Rearrange load to allow proper |
| detection and correction system. If | spinning |
| individual heavy articles are loaded |
|
| (ex. bath mat, both robe, etc.), this |
|
| system may stop spinning or even |
|
| interrupt the spin cycle altogether. |
|
•If the laundry is still too wet at the end of the cycle, add smaller articles of laundry to balance the load and repeat the spin cycle.
|
|
|
|
|
| • Is the door | Close the door. | |
|
|
|
|
|
| |||
|
|
|
|
|
| ❋ If “ | ”is not released, call for service. | |
|
|
|
|
|
| opened? |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Unplug the power plug and call for | |
|
|
|
|
|
|
| service. |
|
|
|
|
|
|
|
|
|
|
• Water overfills due to the faulty water |
|
| ||||||
valve. | Close the water tap. | |||||||
|
|
|
|
|
|
| Unplug the power plug. | |
|
|
|
|
|
|
| ||
• Water level sensor has malfunctioned. | Call for service. | |||||||
|
| |||||||
|
|
| ||||||
• Over load in motor. |
|
| ||||||
|
|
| ||||||
• Over load in motor. |
|
| ||||||
|
| |||||||
• Check water supply. | Turn the tap on. | |||||||
|
|
|
|
|
|
| ❋ If “ | ” is not released, unplug |
|
|
|
|
|
|
| power plug and call for service. | |
26